Fuel Tank Breather - Replace
Show/hide table
| NOTICE |
|---|
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to Special Publication, NENG2500, "Caterpillar Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Caterpillar products. Dispose of all fluids according to local regulations and mandates. |
Show/hide table
 | |
| Illustration 1 | g01621378 |
Show/hide table
 | |
| Illustration 2 | g01621382 |
The fuel tank breather is located on the rear of the machine.
- Park the machine on a level surface. Engage the parking brake.
- Lower the bowl to the ground. Shut off the engine.
- Remove the bolts on the fuel tank breather guard. Remove the fuel tank breather guard (1) .
- Turn the fuel tank breather (2) counterclockwise in order to remove the breather. Replace the fuel tank breather.
- Replace the fuel tank breather guard (1) .
Caterpillar Information System:
2008/08/11 An Improved Pump Control Valve Is Available For the Implement/Steering Pumps That Are Used on Certain Backhoe Loaders and Small Wheel Loaders {5455}
2008/08/04 Proper use of the Set Screw on the Pump Control Can Improve Reliability {5070, 5455}
2008/08/11 The Adjustment Plug for the Margin Pressure on the Pump Control Valve Has Been Improved {5070, 5455}
906H2, 907H2 and 908H2 Compact Wheel Loaders Machine Electronic Control E977 Unexpected Drive Pump Signal Pressure Detection Disabled
613G Wheel Tractor-Scraper Hydraulic System Service Brake - Adjust
993K Wheel Loader Power Train Final Drive and Wheel - Install
906H2, 907H2 and 908H2 Compact Wheel Loaders Machine Electronic Control E976 Unexpected Drive Pump Signal Pressure Detected
D7E Track-Type Tractor Machine Systems Receiver-Dryer - Remove and Install
D7E Track-Type Tractor Machine Systems Refrigerant Evaporator Coil - Remove and Install
D7E Track-Type Tractor Machine Systems Refrigerant Condenser Fan and Fan Motor - Remove and Install
Repair Procedure for Exhaust Leak{1062} Repair Procedure for Exhaust Leak{1062}
D7E Track-Type Tractor Machine Systems Refrigerant Condenser - Remove and Install
2008/09/22 Improvements Have Been Made to the Water Lines Groups {1380}
2008/10/06 Improvements To The Medium Wheel Loader Ride Control Accumulator {5004, 5077}
613G Wheel Tractor-Scraper Steering System Vane Pump (Implement, Steering)
2008/09/22 New Actuator Groups Are Now Installed On The Implement Valves {5051, 5264}
613G Wheel Tractor-Scraper Steering System Steering Time - Check
D11T Track-Type Tractor Ladder System
Installation of the 318-8496 Engine Kit (Power Optimization) for the 980H Wheel Loader{1000} Installation of the 318-8496 Engine Kit (Power Optimization) for the 980H Wheel Loader{1000}
2008/09/29 A New Pilot Valve for the Elevator is Now Available on Certain Wheel Tractor-Scrapers {5059, 5304}
613G Wheel Tractor-Scraper Steering System Pump Control Valve (Secondary Steering) - Test and Adjust
2008/08/11 New C18 Cylinder Liners and O-ring Seals are Used {1201, 1216, 1216}
2008/08/11 Missing Backflow Check Valve {5068}
PL61 Pipelayer Machine Systems Hydraulic Accumulator (Boom, Hook) - Disassemble