Cutting Edges and End Bits - Inspect/Replace
Show/hide table
Ilustrasi 1 | g01289926 |
- Naikkan bulldozer blade dan ganjal bulldozer blade. Pada saat melepaskan cutting edge dan end bit, jaga agar bulldozer blade tetap berada pada ketinggian minimum.
- Lepaskan baut. Kemudian lepaskan cutting edge dan end bit.
- Bersihkan seluruh permukaan yang saling bersinggungan.
- Periksa sisi yang berlawanan di cutting edge. Apabila sisi berlawanan di cutting edge tidak aus, putar sisi yang berlawanan di cutting edge ke arah luar dan pasang cutting edge.
- Apabila kedua sisi cutting edge telah aus, pasang cutting edge yang baru.
- Ulangi Langkah 4 dan 5 untuk end bit.
- Pasang semua baut dan kencangkan baut pada torsi yang ditentukan.
Referensi Untuk mendapatkan informasi selengkapnya, gunakan petunjuk pada Specifications, SENR3130, "Torque Specifications".
- Naikkan bulldozer blade dan lepaskan ganjal. Turunkan bulldozer blade ke tanah.
- Setelah mengoperasikan alat berat selama beberapa jam, periksa semua baut terhadap torsi yang benar.
Caterpillar Information System:
953D Track-Type Loader Machine Systems Fan and Gear Motor (Hydraulic Fan) - Remove
953D Track-Type Loader Machine Systems Piston Pump (Implement) - Install
953D Track-Type Loader Machine Systems Piston Pump (Implement) - Remove
953D Track-Type Loader Machine Systems Lift Cylinder - Remove and Install
Machining and Welding Information for Underground Articulated Trucks Front Frame
Machining and Welding Information for Underground Articulated Trucks Rear Frame
Load Haul Dump Machine Machining & Welding Information Consumables
D11R Starter Solenoid Connections{1467} D11R Starter Solenoid Connections{1467}
657G Wheel Scraper Power Train Final Drive and Wheel - Install
657G Wheel Scraper Power Train Final Drive and Wheel - Remove
D6K Track-Type Tractor Electrohydraulic Power Train Track Roller
657G Wheel Scraper Power Train Power Train Guard (Transmission) - Remove and Install
D7G Series 2 and D7G Series II Track-Type Tractors Battery Disconnect Switch
657G Wheel Tractor-Scraper Machine Systems Steering Control Valve - Remove
D7G Series 2 and D7G Series II Track-Type Tractors Fuses and Circuit Breakers - Replace/Reset
953D Track-Type Loader Machine Systems Fan and Gear Motor (Hydraulic Fan) - Install
657G Wheel Tractor-Scraper Machine Systems Steering Control Valve - Install
D7G Series 2 and D7G Series II Track-Type Tractors Radiator Pressure Cap - Clean/Replace
953D Track-Type Loader Machine Systems Gear Motor (Fan) - Disassemble
953D Track-Type Loader Machine Systems Gear Motor (Fan) - Assemble
D7G Series 2 and D7G Series II Track-Type Tractors Ripper Tip and Shank Protector - Inspect/Replace
993K Wheel Loader Hydraulic Oil Tank Filter Element (Case Drain) (Steering) (Brake) - Replace
993K Wheel Loader Hydraulic System Oil (Steering) (Brake) - Change
953D Track-Type Loader Power Train Piston Pump (Hydrostatic) - Install - Right Side