AccuGrade® GPS (CD700) Caterpillar

Note: The "Vertical Offset Increment" dialog is a site selectable feature. Consult your site supervisor in order to turn this feature ON.

If this feature is turned ON, the "Vertical Offset Increment" dialog is used in order to set the amount each press of the vertical offset buttons will increase or decrease the vertical offset.

Complete the following steps in order to modify the value for the "Vertical Offset Increment" dialog.

1. Press the "Setup Menu" Soft Key.

Show/hide table



Illustration 1	g01269816

2. Press "Setup Menu – Configuration".

   Press the up arrow or the down arrow until "Increment Switch Adjustment" is highlighted.

Show/hide table



Illustration 2	g01269805

3. Press the "OK" key.

   The dialog that is shown in Illustration 2 is shown.

   Complete one of the following steps:

   1. Press the arrow keys in order to enter the amount that each press of the vertical offset buttons will increase or decrease the vertical offset.

   2. Press the "Default 0.010" soft key in order to set the system default. The system default is 0.010 m (0.05 ft).

4. Press the "OK" key in order to save the settings and return to the "Setup Menu-Configuration" dialog.

5. Press the "ESC" key in order to exit the "Plan View". The changes take effect immediately.