C13 and C15 On-highway Engines Caterpillar


Intake Manifold Air Pressure Is Low

Usage:

C15 B5R
This procedure covers the following code:

Table 1
Event Code for Low Intake Manifold Pressure 
J1939 Code  Description  Information 
102-18  Engine Intake Manifold #1 Pressure : Low - Moderate Severity (2)  The intake manifold pressure is below the expected value. A snapshot is triggered. The code is logged. The engine is derated. The derate is cleared when the condition no longer exists. 

Probable Causes

  • Air inlet restrictions

  • Leaks between the turbocharger compressor and the intake manifold

  • Improper fuel flow to the engine

Air Inlet Restrictions

Check for restrictions in the air inlet system. Refer to the Systems Operation/Testing and Adjusting manual for information on inspecting the air inlet system.

Leaks Between the Turbocharger Compressor and the Intake Manifold

Look for the following problems in the lines between the turbocharger compressor and the intake manifold:

  • Damaged hoses

  • Loose clamps

  • Cracked fittings

Repair any problems. Replace parts, if necessary.

Fuel System

Incorrect fuel flow to the engine can cause low boost. Refer to Troubleshooting, "Fuel System Pressure - Test" in order to properly test the fuel system.

Caterpillar Information System:

330D, 336D, 336D2, 340D and 340D2 Excavators and 336D MHPU Mobile Hydraulic Power Unit Machine Systems Bucket Linkage Bearings and Seals - Install
C175 Generator Set Engines Engine Oil Pan - Remove
3512B Oil Well Servicing Engine (ADEM III) Fuel Position Multiplier
3512C Petroleum Engines Override Switch
CX28, CX31 and CX35 On-Highway Transmissions Power Train Electronic Control System Programmable Parameters
C7 On-highway Engine Solenoid Valve
TH35 Well Servicing Transmissions Transmission and Torque Converter - Connect
3500 and 3500B High Displacement Engines for Caterpillar Built Machines Valve Mechanism Cover Base - Remove and Install
3512C Petroleum Engines System Overview
345C MHPU Mobile Hydraulic Power Unit Machine Systems Swivel - Install
2005/12/26 Operator Control Handle Mounting Change {3065, 5063, 5705}
320D and 323D Excavators Machine System Specifications Track Adjuster
C7 Urban Transit Bus Engines Reference Material
CX31 On-Highway Transmission Torque Converter Housing
2005/12/19 New Piston and Rod Group {1225}
345D, 349D and 349D2 Excavator Machine System Specifications Fasteners
3512 Industrial Engine Exhaust Manifold
C27 and C32 Generator Set Engines Engine Oil Filter Base
325D and 329D Excavators and 325D Material Handler Machine System Specifications Bucket Adjuster
3512C Petroleum Engines Diagnostic Code List
3512C Petroleum Engines Event Code List
C7 On-highway Engine Belt Tensioner
C175 Generator Set Engines Engine Oil Pan - Disassemble
C13 On-highway Engine Clean Gas Induction Cooler
Back to top
The names Caterpillar, John Deere, JD, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
CH-Part.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only.