Crankcase Breather
Show/hide table
Illustration 1 | g01322247 |
Typical example |
(1) Breather
- Tighten the breather to the following torque. ...
8 N·m (70 lb in)
(2) Setscrews
- Tighten the setscrews to the following torque. ...
4.4 N·m (39 lb in)
Align the outlet of the breather to the flexible pipe.
Show/hide table
Illustration 2 | g01322248 |
Typical example |
(3) Clamps
- Tighten the clamps to the following torque. ...
5 N·m (44 lb in)
(4) Setscrews
- Tighten the setscrews to the following torque. ...
22 N·m (16 lb ft)
(4) Canister
- Tighten the canister to the following torque. ...
12 N·m (106 lb in)
Caterpillar Information System:
C13 and C15 On-highway Engines Engine Speed - Test
C13 and C15 On-highway Engines Sensor Supply - Test
C13 and C15 On-highway Engines Shutdown Timer (PTO) - Test
TH48-E80 Oil/Gas Transmission Gear Pump (Torque Converter and Transmission) - Install
3618 Engine Auxiliary Water Pump - Disassemble
TH48-E80 Oil/Gas Transmission Gear Pump (Torque Converter and Transmission) - Remove
C9 Generator Set Electronic Modular Control Panel 3 (EMCP 3)
C13 and C15 On-highway Engines Retarder - Test
Caterpillar 270 Air Compressor Rebuilt Air Compressor - Test
C13 and C15 On-highway Engines Variable Valve Actuator - Test
C32 Marine and Auxiliary Marine Engines Heat Exchanger - Install
3412E, C30 and C32 Marine Engines Heat Exchanger - Assemble - Without Fuel Cooler
2005/08/15 Improved Spin-On Engine Oil Filters are Used {1308}
TH48-E80 Oil/Gas Transmission Gear Pump (Torque Converter and Transmission) - Disassemble
TH48-E80 Oil/Gas Transmission Gear Pump (Torque Converter and Transmission) - Assemble
ES12F, UPS 1000S and UPS 1200S Uninterruptible Power Supplys Starting and Stopping
TH48-E80 Oil/Gas Transmission Lockup Clutch and Solenoid Valve (Torque Converter) - Remove
C15 On-Highway Engine Fuel System - Prime
C-12 Generator Set Engine CID 0091 FMI 08 Throttle Position signal abnormal
TH48-E80 Oil/Gas Transmission Lockup Clutch and Solenoid Valve (Torque Converter) - Install
TH48-E80 Oil/Gas Transmission Lockup Clutch and Solenoid Valve (Torque Converter) - Disassemble
3618 Engine Auxiliary Water Pump - Assemble
3456 Generator Sets Starting the Engine - EMCP 3 (If Equipped)
ES12F, UPS 1000S and UPS 1200S Uninterruptible Power Supplys Device Bus Network - Modbus Communications