Heat Exchanger - Install
Show/hide table
Required Tools | |||
---|---|---|---|
Tool | Part Number | Part Description | Qty |
A | 138-7573 | Link Bracket | 4 |
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Attach Tooling (A) and a suitable lifting device to heat exchanger (12). The weight of heat exchanger (12) is approximately
89 kg (196 lb) . - Position heat exchanger (12) on the engine and install bolts (10) and washers (12).
- Tighten bolts (10) to a torque of
105 ± 20 N·m (77 ± 15 lb ft) .Show/hide tableIllustration 2 g01185269 - Install hose assemblies (8) and (9).
Show/hide table
Illustration 3 g01185179 - Install bolts (4), the washers, and the nuts.
- Tighten bolts (4) to a torque of
105 ± 20 N·m (77 ± 15 lb ft) . - Install level sensor (6).
- Install tube assembly (2).
- Install hose assemblies (1), (3), (5), and (7).
Show/hide table
Illustration 1 | g01185347 |
Caterpillar Information System:
3412E, C30 and C32 Marine Engines Heat Exchanger - Assemble - Without Fuel Cooler
3126B Generator Set Engine Low Power/Poor or No Response to Throttle
TH48-E80 Petroleum Transmission Power Train Electronic Control System MID 027 - CID 0590 - FMI 09
3126B Generator Set Engine Intermittent Low Power or Power Cutout
3126B Generator Set Engine Intermittent Engine Shutdown
C27 and C32 Generator Sets Safety Messages
C-12 Generator Set Engine Excessive White Smoke
345C MHPU Mobile Hydraulic Power Unit Engine Supplement Engine Oil Cooler - Remove and Install - In Chassis
3412E, C30 and C32 Marine Engines Heat Exchanger - Disassemble - Without Fuel Cooler
2005/08/01 Correct Timing Procedure for the Engine {1206, 1212}
C4.4 and C6.6 Industrial Engines and Engines for Caterpillar Built Machines CID 0261 FMI 11
C4.4 and C6.6 Engines for Caterpillar Built Machines CID 0342 FMI 08
C13 and C15 On-highway Engines Variable Valve Actuator - Test
Caterpillar 270 Air Compressor Rebuilt Air Compressor - Test
C13 and C15 On-highway Engines Retarder - Test
C9 Generator Set Electronic Modular Control Panel 3 (EMCP 3)
TH48-E80 Oil/Gas Transmission Gear Pump (Torque Converter and Transmission) - Remove
3618 Engine Auxiliary Water Pump - Disassemble
TH48-E80 Oil/Gas Transmission Gear Pump (Torque Converter and Transmission) - Install
C13 and C15 On-highway Engines Shutdown Timer (PTO) - Test
C13 and C15 On-highway Engines Sensor Supply - Test
C13 and C15 On-highway Engines Engine Speed - Test
C6.6 Industrial Engine Crankcase Breather
2005/08/15 Improved Spin-On Engine Oil Filters are Used {1308}