Turbocharger - Assemble
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
Show/hide table
NOTICE |
---|
The compressor housing must remain straight with the turbocharger cartridge during disassembly and assembly. Tilting may cause damage to the tips of the compressor wheel and the compressor shaft. |
- Position compressor housing (5) and turbine housing (1) on turbocharger cartridge (3).
Note: Ensure that the mating surfaces are flush.
- Tighten the nuts on V-band clamp (4) to a torque of
14 ± 1 N·m (10 ± 1 lb ft) . Use a soft hammer to lightly hit around the diameter of the band clamp. Tighten the nuts again to a torque of14 ± 1 N·m (10 ± 1 lb in) . - Tighten the nuts on V-band clamp (2) to a torque of
14 ± 1 N·m (10 ± 1 lb in) . Use a soft hammer to lightly hit around the diameter of the band clamp. Tighten the nuts again to a torque of14 ± 1 N·m (10 ± 1 lb in) . - Ensure that the impeller spins freely.
Show/hide table
Illustration 1 | g01181823 |
End By:
- Install the turbocharger. Refer to Disassembly and Assembly, "Turbocharger - Install".
Caterpillar Information System:
3126B Petroleum Engine Turbocharger - Assemble
C32 Marine and Auxiliary Marine Engines Turbocharger - Disassemble
C13 On-highway Engine Alternator Mounting
C6.6 Engines for Caterpillar Built Machines Piston Cooling Jet
C9-XQ300 Rental Generator Set Cooling System Coolant (ELC) - Change
TH48-E80 Petroleum Transmission Transmission Planetary
C7 and C9 On-Highway Engines Sensor Supply - Test
C13 and C15 On-highway Engines Engine Overspeeds
C7 and C9 On-Highway Engines Oil Pressure Is Low
3126B Petroleum Engine Turbocharger - Disassemble
C15 and C18 Petroleum Generator Sets Engine Performance - Test - Standby Generator Sets
3126B Petroleum Engine Turbocharger - Remove
3126B Petroleum Engine Turbocharger - Install
3126B Petroleum Engine Exhaust Manifold - Remove and Install
2005/06/27 New Gaskets for the Turbocharger Oil Lines are Now Used {1052, 1307}
C6.6 Engines for Caterpillar Built Machines Fuel Filter Base
C32 Marine Engines Exhaust Manifold - Remove and Install
2005/07/04 Improved Spacer for the Prechamber Group {1106}
Caterpillar 270 Air Compressor No Compression of Air (Unloaded)
Caterpillar 270 Air Compressor General Troubleshooting Information
C13 and C15 On-highway Engines Clean Gas Induction - Test
C15 and C18 Petroleum Generator Sets Engine Oil Sample - Obtain
Caterpillar 270 Air Compressor Air Compressor Cycles Constantly
Caterpillar 270 Air Compressor Air Compressor is Noisy