Oil Pressure Is Low
Use this procedure to troubleshoot a low oil pressure condition. Also, this procedure covers the following diagnostic trouble codes:
Show/hide table
Diagnostic Trouble Codes for Low Oil Pressure     | ||
---|---|---|
J1939 Code     | Description     | Information     |
100-17     | Engine Oil Pressure : Low - Least Severe (1)     | Refer to Illustration 1. Oil pressure is below line (1) for at least eight seconds. A snapshot is triggered. The code is logged. Engine performance is not affected.     |
100-1     | Engine Oil Pressure : Low - Most Severe (3)     | Refer to Illustration 1. Oil pressure is below line (3) for at least four seconds. Engine power is reduced while this condition exists. A snapshot is triggered. The code is logged. Factory passwords are required in order to clear the logged code. If the low oil pressure condition continues for more than 30 seconds and the "Engine Monitoring Mode" parameter is programmed to "Shutdown", the Engine Control Module (ECM) will shut down the engine.     |
Show/hide table
Illustration 1 | g01336004 |
Chart for low oil pressure (1) Trip line for engine oil pressure : low - least severe (1) (3) Trip line for engine oil pressure : low - most severe (3) |
Perform the following procedure:
- Check the oil level. Refer to the Operation and Maintenance Manual for the correct procedure.
- Test the engine oil pressure. Refer to Systems Operation/Testing and Adjusting, "Engine Oil Pressure - Test" for the correct procedure.
If the readings are low, refer to "Reasons for Low Engine Oil Pressure" in the Systems Operation/Testing and Adjusting manual. Make the necessary repairs.
Caterpillar Information System:
3126B Petroleum Engine Turbocharger - Disassemble
C15 and C18 Petroleum Generator Sets Engine Performance - Test - Standby Generator Sets
3126B Petroleum Engine Turbocharger - Remove
C32 Marine Engines Turbocharger - Remove
3126B Petroleum Engine Electronic Unit Injector Sleeve - Install
3126B Petroleum Engine Electronic Unit Injector Sleeve - Remove
C7.1 Engines for Caterpillar Built Machines Camshaft
C15 and C18 Tier 4 Final Engines Vibration Damper - Check
C32 Marine and Auxiliary Marine Engines Fuel Transfer Pump - Install
120H and 135H Motor Graders Hydraulic and Steering System Relief Valve (Scarifier)
C32 Marine and Auxiliary Marine Engines Fuel Transfer Pump - Remove
C7 and C9 On-Highway Engines Fuel Injection Pump - Test
C13 and C15 On-highway Engines Engine Overspeeds
C7 and C9 On-Highway Engines Sensor Supply - Test
TH48-E80 Petroleum Transmission Transmission Planetary
C9-XQ300 Rental Generator Set Cooling System Coolant (ELC) - Change
C6.6 Engines for Caterpillar Built Machines Piston Cooling Jet
C13 On-highway Engine Alternator Mounting
C32 Marine and Auxiliary Marine Engines Turbocharger - Disassemble
3126B Petroleum Engine Turbocharger - Assemble
C32 Marine and Auxiliary Marine Engines Turbocharger - Assemble
3126B Petroleum Engine Turbocharger - Install
3126B Petroleum Engine Exhaust Manifold - Remove and Install
2005/06/27 New Gaskets for the Turbocharger Oil Lines are Now Used {1052, 1307}