Turbocharger - Disassemble
Start By:
- Remove the turbocharger. Refer to Disassembly and Assembly, "Turbocharger - Remove".
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Loosen V-band clamp (4) and V-band clamp (2).
- Separate compressor housing (5) from turbocharger cartridge (3).
- Separate turbine housing (1) from turbocharger cartridge (3).
Show/hide table
Illustration 1 | g01181823 |
Note: Put marks on the housing for the assembly purpose.
Caterpillar Information System:
C13 On-highway Engine Alternator Mounting
C6.6 Engines for Caterpillar Built Machines Piston Cooling Jet
C9-XQ300 Rental Generator Set Cooling System Coolant (ELC) - Change
TH48-E80 Petroleum Transmission Transmission Planetary
C7 and C9 On-Highway Engines Sensor Supply - Test
C13 and C15 On-highway Engines Engine Overspeeds
C7 and C9 On-Highway Engines Oil Pressure Is Low
3126B Petroleum Engine Turbocharger - Disassemble
C15 and C18 Petroleum Generator Sets Engine Performance - Test - Standby Generator Sets
3126B Petroleum Engine Turbocharger - Remove
C32 Marine Engines Turbocharger - Remove
3126B Petroleum Engine Electronic Unit Injector Sleeve - Install
3126B Petroleum Engine Turbocharger - Assemble
C32 Marine and Auxiliary Marine Engines Turbocharger - Assemble
3126B Petroleum Engine Turbocharger - Install
3126B Petroleum Engine Exhaust Manifold - Remove and Install
2005/06/27 New Gaskets for the Turbocharger Oil Lines are Now Used {1052, 1307}
C6.6 Engines for Caterpillar Built Machines Fuel Filter Base
C32 Marine Engines Exhaust Manifold - Remove and Install
2005/07/04 Improved Spacer for the Prechamber Group {1106}
Caterpillar 270 Air Compressor No Compression of Air (Unloaded)
Caterpillar 270 Air Compressor General Troubleshooting Information
C13 and C15 On-highway Engines Clean Gas Induction - Test
C15 and C18 Petroleum Generator Sets Engine Oil Sample - Obtain