Cylinder Block Cover Group
Show/hide table
 | |
| Illustration 1 | g01522094 |
Left side view of engine (3) Cover | |
(2) Install the gasket so that the bead is facing the cover.
Note: Apply 1U-8846 Gasket Sealant to the gasket surface that is on the cover. Spread the sealant uniformly on the face of the cover and around the bolt holes. The cover must be installed and tightened within ten minutes.
(4) Use 12 spacers along the bottom row of bolts for each of the cover.
(5) Install the sleeve in six locations (1) .
Show/hide table
 | |
| Illustration 2 | g01160766 |
Use the following procedure in order to tighten the bolts of the cover:
- Tighten the bolt 1 through 8 on each cover in a numerical sequence that is shown in Illustration 2 to the standard torque.
- Again tighten the bolt 1 through 8 on each cover in a numerical sequence that is shown in Illustration 2 to the standard torque.
Caterpillar Information System:
3500 Industrial and Generator Set Engines Overhaul Considerations
C4.4 (Mech) Industrial Engine Starting with Jump Start Cables
C4.4 Industrial Engine Before Starting Engine
C6.6 Industrial Engine Diagnostic Flash Code Retrieval
3500 Industrial and Generator Set Engines Magnetic Pickups - Clean/Inspect - If Equipped
3406E Marine Engine Pistons and Connecting Rods - Assemble
C4.4 Industrial Engine Engine Starting
C4.4 Industrial Engine Burn Prevention
C4.4 Industrial Engine General Hazard Information
3406E Marine Engine Pistons and Connecting Rods - Disassemble
C9 Engine for Caterpillar Built Machines Engine Oil Filter Base and Oil Cooler - Remove
793F Off-Highway Truck Differential Warm-up and Break-in
3044C Industrial Engine Cold Weather Operation
C27 and C32 Industrial and Petroleum Engines E2143 Low Engine Coolant Level
2005/05/01 New Hold Down Bracket Assembly for the Turbocharger Oil Line {1052, 1307}
C9 Engine for Caterpillar Built Machines Engine Oil Filter Base and Oil Cooler - Install
3406E Marine Engine Fuel Temperature Sensor - Remove and Install
3406E and C15 Marine Engines Inlet Air Temperature Sensor - Remove and Install
325D and 329D Excavators Hydraulic System Swivel
3406E and C15 Marine Engines Turbocharger Outlet Pressure Sensor - Remove and Install
3406E Marine Engine Camshaft Position Sensor - Remove and Install
C4.4 Industrial Engine Battery Electrolyte Level - Check
C4.4 Industrial Engine Engine - Clean
3406E Marine Engine Fuel Pressure Sensor - Remove and Install