Turbocharger Outlet Pressure Sensor - Remove and Install
拆卸步骤
Show/hide table
注意 |
---|
保持所有零件清洁无杂质。 杂质会造成快速磨损和缩短部件寿命。 |
- 断开线束组件 (1) 。
Show/hide table
图 1 | g01171783 |
- 将涡轮增压器输出压力传感器 (2) 从缸盖上拆下。
- 然后从涡轮增压器出口压力传感器 (2) 上拆下 O 形密封圈。
安装步骤
Show/hide table
注意 |
---|
保持所有零件清洁无杂质。 杂质会造成快速磨损和缩短部件寿命。 |
- 为涡轮增压器出口压力传感器 (2) 安装一个新的 O 形密封圈。
Show/hide table
图 2 | g01171783 |
- 安装涡轮增压器出口压力传感器 (2) 。 将涡轮增压器出口压力传感器拧紧至扭矩为 10 ± 2 N·m (89 ± 18 lb in)。
- 连接线束组件 (1) 。
Caterpillar Information System:
325D and 329D Excavators Hydraulic System Swivel
3406E and C15 Marine Engines Inlet Air Temperature Sensor - Remove and Install
3406E Marine Engine Fuel Temperature Sensor - Remove and Install
C9 Engine for Caterpillar Built Machines Engine Oil Filter Base and Oil Cooler - Install
2005/05/01 New Hold Down Bracket Assembly for the Turbocharger Oil Line {1052, 1307}
C27 and C32 Industrial and Petroleum Engines E2143 Low Engine Coolant Level
3044C Industrial Engine Cold Weather Operation
C7 On-highway Engine Cylinder Block Cover Group
3500 Industrial and Generator Set Engines Overhaul Considerations
C4.4 (Mech) Industrial Engine Starting with Jump Start Cables
C4.4 Industrial Engine Before Starting Engine
C6.6 Industrial Engine Diagnostic Flash Code Retrieval
3406E Marine Engine Camshaft Position Sensor - Remove and Install
C4.4 Industrial Engine Battery Electrolyte Level - Check
C4.4 Industrial Engine Engine - Clean
3406E Marine Engine Fuel Pressure Sensor - Remove and Install
3406E and C15 Marine Engines Crankshaft Position Sensor - Remove and Install
3406E and C15 Marine Engines Engine Oil Pressure Sensor - Remove and Install
C32 Petroleum Engines Plate Locations and Film Locations
3406E Marine Engine Coolant Temperature Sensor - Remove and Install
2005/05/30 New Strainer for the Air Starting Motor {1451}
3406E and C15 Marine Engines Coolant Level Sensor - Remove and Install
2005/06/06 New Inlet Manifold Pressure Sensors are Available {1058, 1923}
2005/06/06 Prevent Spontaneous Engine Shutdown {1000}