Engine Oil Filter Base and Oil Cooler - Install
Show/hide table
注意 |
---|
保持所有零件清洁无杂质。 杂质会造成快速磨损和缩短部件寿命。 |
- 安装密封垫和发动机机油冷却器 (5)。
Show/hide table
图 2 g01271362 Show/hide table图 3 g01104432 - 在油封上涂抹清洁的发动机机油。 在发动机机油滤清器座 (3) 中安装油封。 将发动机机油滤清器座 (3) 放置在发动机机油冷却器上。 安装螺栓 (4)。 按照数字顺序依次拧紧螺栓。 连接软管组件 (2)。
Show/hide table
图 4 g01171123 - 安装发动机机滤清器 (1)。
- 向发动机中加注冷却液至正确液位。 请参考操作和保养手册, "冷却系统冷却液 - 更换"。
Show/hide table
图 1 | g01150963 |
Caterpillar Information System:
2005/05/01 New Hold Down Bracket Assembly for the Turbocharger Oil Line {1052, 1307}
C27 and C32 Industrial and Petroleum Engines E2143 Low Engine Coolant Level
3044C Industrial Engine Cold Weather Operation
C7 On-highway Engine Cylinder Block Cover Group
3500 Industrial and Generator Set Engines Overhaul Considerations
C4.4 (Mech) Industrial Engine Starting with Jump Start Cables
C4.4 Industrial Engine Before Starting Engine
C6.6 Industrial Engine Diagnostic Flash Code Retrieval
3500 Industrial and Generator Set Engines Magnetic Pickups - Clean/Inspect - If Equipped
3406E Marine Engine Pistons and Connecting Rods - Assemble
C4.4 Industrial Engine Engine Starting
C4.4 Industrial Engine Burn Prevention
3406E Marine Engine Fuel Temperature Sensor - Remove and Install
3406E and C15 Marine Engines Inlet Air Temperature Sensor - Remove and Install
325D and 329D Excavators Hydraulic System Swivel
3406E and C15 Marine Engines Turbocharger Outlet Pressure Sensor - Remove and Install
3406E Marine Engine Camshaft Position Sensor - Remove and Install
C4.4 Industrial Engine Battery Electrolyte Level - Check
C4.4 Industrial Engine Engine - Clean
3406E Marine Engine Fuel Pressure Sensor - Remove and Install
3406E and C15 Marine Engines Crankshaft Position Sensor - Remove and Install
3406E and C15 Marine Engines Engine Oil Pressure Sensor - Remove and Install
C32 Petroleum Engines Plate Locations and Film Locations
3406E Marine Engine Coolant Temperature Sensor - Remove and Install