Engine Crankcase Breather Element - Replace
Show/hide table
Illustration 1 | g01156334 |
The breather assembly (1) The O-ring for the top cover (2) The top cover (3) The O-ring for the filter element (4) The filter element (5) The breather body (6) The side cover |
Show/hide table
NOTICE |
---|
Ensure that the components of the breather assembly are installed in the correct position. If installed incorrectly, engine damage can result. |
Note: There are several vent holes under the top cover (2) and under the side cover (6). Keep the area around the vent holes clean. Do not restrict the vent holes.
- Remove all dirt and oil from the outside of the breather assembly. Remove the top cover (2) by turning the top cover counterclockwise until the lugs disengage. The breather element includes an O ring (3). Remove the breather element (4) by turning and lifting the element. Discard the element. Clean the inner surfaces of the breather body (5). Clean the top cover and inspect the O ring (1) in the top cover. If the O ring in the top cover is worn or damaged, replace the O ring.
- Lubricate the O ring (3) in the new filter element (4) with clean engine lubricating oil. Carefully insert the element into the breather body (5). Lubricate the O ring (1) in the top cover with clean engine lubricating oil. Carefully insert the top cover (2) into the breather body (5). Rotate the top cover clockwise until the lugs are fully engaged.
Caterpillar Information System:
C7.1 (Mech) Industrial Engine Water Pump - Inspect
C4.4 (Mech) Marine Generator Set MCS-3 Water Connection Group
C15 and C18 Petroleum Generator Sets Fuel System Secondary Filter - Replace
C4.4 (Mech) Marine Generator Set MCS-3 Fuel Lines
C4.4 Marine Auxiliary Generator Set Engine Crankcase Breather
C4.4 (Mech) Marine Generator Set MCS-3 Exhaust Elbow
C4.4 (Mech) Marine Generator Set MCS-3 Water Lines - Engines with a Keel Cooler
C32 Petroleum Engines Model View Illustrations
C4.4 Marine Generator Set Engines Flywheel - Install
C4.4 Marine Generator Set Engines Flywheel - Remove
G3400 Engines (EIS) Inspecting Electrical Connectors
C4.4 Marine Generator Set Engines Water Temperature Regulator - Remove and Install
C2.2 Engine and C1.5 Generator Set Engine Design
C2.2 Engine and C1.5 Generator Set Fuel Injection Lines
C6.6 Industrial Engine Fuel System Primary Filter (Water Separator) Element - Replace
C2.2 Engine and C1.5 Generator Set Fuel Injection Pump
C2.2 Engine and C1.5 Generator Set Fuel Injection Nozzles
C2.2 Engine and C1.5 Generator Set Lifter Group
C2.2 Engine and C1.5 Generator Set Rocker Shaft
C2.2 Engine and C1.5 Generator Set Valve Mechanism Cover
C2.2 Engine and C1.5 Generator Set Cylinder Head Valves
C2.2 Engine and C1.5 Generator Set Cylinder Head
C2.2 Engine and C1.5 Generator Set Exhaust Manifold
C2.2 Engine and C1.5 Generator Set Camshaft