C-10 and C-15 Petroleum Engines Caterpillar


Diagnostic Code Cross Reference

Usage:

C-10 Z2B
Problems with the electronic control system are reported via these types of codes: flash codes, diagnostic codes, and event codes.

For information on flash codes, refer to Troubleshooting, "Flash Codes".

For information on diagnostic codes, refer to Troubleshooting, "Diagnostic Codes".

For information on event codes, refer to Troubleshooting, "Event Codes".

Use Table 1 as a cross-reference between the various types of codes.

Portions of this material are reprinted with permission from SAE J1939DA_201607© 2016 SAE International. SAE International is not responsible for any use or translation of this material, in whole or in part. Please contact SAE International to obtain a complete copy of SAE J1939DA_201607, the official definitive source of this standard.

Table 1
Cross Reference for Flash Codes 
Flash Code  Diagnostic
or
Event Code 
SPN/FMI Code  Description of Code 
N/A  E443  1835-00  High Auxiliary Pressure 
E445 1836-00  High Auxiliary Temperature 
545-05 545-05  Ether Start Relay open/short to +batt 
545-06 545-06  Ether Start Relay short to ground 
1835-03 1835-03  Auxiliary Pressure Sensor open/short to +batt 
1835-04 1835-04  Auxiliary Pressure Sensor short to ground 
1836-08 1836-08  Auxiliary Temperature Sensor abnormal signal 
13  174-03  174-03  Fuel Temperature open/short to +batt 
174-04 174-04  Fuel Temperature short to ground 
21  41-03  N/A  8 Volt DC Supply short to +batt 
41-04 N/A  8 Volt DC Supply short to ground 
262-03 620-03  5 Volt Sensor DC Power Supply short to +batt 
262-04 620-04  5 Volt Sensor DC Power Supply short to ground 
263-03 678-03  Digital Sensor Supply short to +batt 
263-04 678-04  Digital Sensor Supply short to ground 
24  100-03  100-03  Engine Oil Pressure open/short to +batt 
100-04 100-04  Engine Oil Pressure short to ground 
25  273-00  102-00  Turbo Outlet Pressure above normal 
273-03 102-03  Turbo Outlet Pressure open/short to +batt 
273-04 102-04  Turbo Outlet Pressure short to ground 
26  274-03  108-03  Atmospheric Pressure open/short to +batt 
274-04 108-04  Atmospheric Pressure short to ground 
27  110-03  110-03  Engine Coolant Temperature open/short to +batt 
110-04 110-04  Engine Coolant Temperature short to ground 
28  91-13  91-13  Throttle Position calibration required 
32  91-08  91-08  Throttle Position signal abnormal 
34  320-02  190-02  Speed/Timing Sensor Loss of Signal 
320-11 190-11  Speed/Timing Sensor mechanical failure 
342-02 723-02  Loss of Secondary Engine Speed signal 
342-11 723-11  Secondary Engine Speed Sensor mechanical failure 
35  E004  0190-16  Engine Overspeed Shutdown 
E190 0190-00  Engine Overspeed Warning 
37  94-03  94-03  Fuel Pressure open/short to +batt 
94-04 94-04  Fuel Pressure short to ground 
38  172-03  172-03  Intake Manifold Air Temp open/short to +batt 
172-04 172-04  Intake Manifold Air Temp short to ground 
42  22-13  N/A  Timing Sensor calibration required 
261-13 228-13  Engine Timing calibration required 
46  E039  0100-18  Low Engine Oil Pressure Derate 
E040 100-01  Low Engine Oil Pressure Shutdown 
E100 100-17  Low Engine Oil Pressure Warning 
51  168-02  168-02  System Voltage intermittent/erratic 
53  254-12  N/A  Electronic Control Module Error 
56  253-02  234-02  Personality Module mismatch 
268-02 1111-02  Check Programmable Parameters 
58  247-09  639-09  J1939 Data Link communications 
61  E015  110-16  High Engine Coolant Temperature Derate 
E016 110-00  High Engine Coolant Temperature Shutdown 
E017 110-15  High Engine Coolant Temperature Warning 
62  E057  111-18  Low Engine Coolant Level Derate 
E058 111-01  Low Engine Coolant Level Shutdown 
E059 111-17  Low Engine Coolant Level Warning 
63  E005  94-15  Fuel Filter Restriction Derate 
E006 94-16  Fuel Filter Restriction Shutdown 
E095 94-00  Fuel Filter Restriction Warning 
E096 94-00  High Fuel Pressure 
64  E025  172-16  High Inlet Air Temperature Derate 
E027 172-15  High Inlet Air Temperature Warning 
65  E054  174-16  High Fuel Temperature Derate 
E055 174-00  High Fuel Temperature Shutdown 
E056 174-15  High Fuel Temperature Warning 
72  1-11  651-11  Injector Cylinder #1 fault 
2-11 652-11  Injector Cylinder #2 fault 
73  3-11  653-11  Injector Cylinder #3 fault 
4-11 654-11  Injector Cylinder #4 fault 
74  5-11  655-11  Injector Cylinder #5 fault 
6-11 656-11  Injector Cylinder #6 fault 

Caterpillar Information System:

C27 and C32 Engines for Caterpillar Built Machines Crankshaft Front Seal - Remove
C27 and C32 Engines for Caterpillar Built Machines Vibration Damper and Pulley - Remove and Install - Type 1
3512C Oil Well Service Engines Model View Illustrations
2005/02/28 New Flash Files Are Available For Cold Mode Starting Strategy {7620}
C27 and C32 Engines for Caterpillar Built Machines Rear Power Take-Off (RPTO) - Install
C27 and C32 Engines for Caterpillar Built Machines Rear Power Take-Off (RPTO) - Remove
G3520C and G3520E Engines Air Lines - Compressor Bypass
C4.4 Generator Sets Alternator - Inspect
C27 and C32 Generator Set Engines Housing (Rear) - Install
3512C HD SR500 Generator Sets Generator Set Vibration - Inspect
C3.3 and C4.4 Generator Sets Generator Set Identification
C27 and C32 Industrial and Petroleum Engines E445 High Auxiliary Temperature
C27 and C32 Engines for Caterpillar Built Machines Crankshaft Front Seal - Install
C3.3 and C4.4 Generator Sets Cooling System Coolant (ELC) - Change
C27 and C32 Generator Set Engines Gear Group (Front) - Remove
C27 and C32 Generator Set Engines Gear Group (Front) - Install
C27 and C32 Engines for Caterpillar Built Machines Housing (Front) - Remove
UPS View User Guide General Information (System Overview)
UPS View User Guide Display
C27 and C32 Engines for Caterpillar Built Machines Housing (Front) - Install
3126B Industrial Engines CID 0094 FMI 04 Fuel Pressure short to ground
C4.4 Generator Sets Engine - Clean
C27 and C32 Generator Set Engines Valve Mechanism Cover - Remove and Install
C27 and C32 Generator Set Engines Valve Mechanism Cover Base - Remove and Install
Back to top
The names Caterpillar, John Deere, JD, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
CH-Part.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only.