Position Sensor (Lift Linkage and Tilt Linkage)
Show/hide table
Information for the Position Sensor     | ||
Pin     | Circuit     | Color     |
A     | +BAT     | OR     |
B     | GND     | BK     |
C     | SIG     | WH     |
Electrical Specifications
-
Voltage
- Nominal voltage ... 24 VDC
- Maximum voltage ... 32 VDC
- Minimum voltage ... 18 VDC
- Maximum voltage ... 32 VDC
-
Frequency
- Nominal frequency ... 500 Hz
- Maximum frequency ... 600 Hz
- Minimum frequency ... 400 Hz
- Maximum frequency ... 600 Hz
-
Duty Cycle
- Duty cycle at full counterclockwise rotation ... 1%
- Duty cycle at full clockwise rotation ... 100%
Note: The position sensor should be viewed from the shaft end.
Rotational range of motion for the shaft between stops ... 200 degrees
Note: The internal stops are designed to limit rotation of the shaft by hand. The stops are not intended to limit the travel of linkages that are attached to the shaft. If the stops are damaged the sensor should be replaced.
Caterpillar Information System:
651E and 657E Wheel Tractor-Scrapers Hydraulic System Ejector Valve (Speed Change) - If Equipped
988G Wheel Loader Engine Supplement Engine Oil Cooler - Install - Engine In Chassis
2000/08/14 A New Relief Valve for the Gear Motor (Fan Drive) Improves the Accuracy of Fan Speed {5069}
910G HYSTAT Wheel Loader Cab Door
3003, 3013, 3014 and 3024 Engines for Caterpillar Built Machines Engine Valve Lash - Inspect/Adjust
994D Wheel Loader Battery - Clean
651E and 657E Wheel Tractor-Scrapers Air System and Brakes Solenoid Valve (Apron)
988G Wheel Loader Engine Supplement Engine Oil Cooler - Remove - Engine In Chassis
988G Wheel Loader Engine Supplement Engine to Torque Converter - Connect
988G Wheel Loader Engine Supplement Engine from Torque Converter - Separate
3003, 3013, 3014 and 3024 Engines for Caterpillar Built Machines Finding Top Center Position for No. 1 Piston
2000/03/27 A Stronger Carrier Roller Mounting Bracket Improves Reliability {4154}
910G HYSTAT Wheel Loader Starting Above 0°C (32°F)
910G HYSTAT Wheel Loader Starting Below 0°C (32°F) with Thermal Starting Aid
651E and 657E Wheel Tractor-Scrapers Air System and Brakes General Information
3524B Engines for Off-Highway Trucks Excessive Black Smoke
963B Track-Type Loader Engine Valve Lash - Check
980G Wheel Loader Steering System Relief Valve (Steering Cylinder Crossover) - Test and Adjust
651E and 657E Wheel Tractor-Scrapers Hydraulic System Sequence and Pressure Control Valve (Apron)
3064 and 3066 Engines for Caterpillar Built Machines Cooling System - Inspect
3054 Engine Cooling System - Test
2000/03/27 Correct Identification of Cutting Edges for Bucket Arrangements {6101, 6103, 6104, 6105, 6139, 6801}
988G Wheel Loader Machine Systems Gear Motor (Hydraulic Fan) - Remove
988G Wheel Loader Machine Systems Gear Motor (Hydraulic Fan) - Install