Starting Below 0°C (32°F) with Thermal Starting Aid
Show/hide table
Do not use aerosol types of starting aids such as ether. Such use could result in an explosion and personal injury. |
- Engage the parking brake.
- Move the direction control lever into NEUTRAL.
- Move the control levers to the HOLD position.
- Depress the top of the thermal starting aid switch. The light bar inside the switch will light.
Show/hide table
Illustration 1 | g00677059 |
- Wait until the light bar inside the switch goes out. Turn the engine start switch key in order to engage the starter motor. Do not crank the engine for more than 30 seconds.
Show/hide table
Illustration 2 | g00688646 |
- If the engine does not start, release the engine start switch key in order to disengage the starter motor. Repeat Steps 4 and 5.
When the engine starts, continue to depress the starting aid switch until the engine runs evenly. Do not depress the starting aid switch for more than 30 seconds after the engine starts.
Caterpillar Information System:
910G HYSTAT Wheel Loader Starting Above 0°C (32°F)
988G Wheel Loader Electrohydraulic System Position Sensor (Lift Linkage and Tilt Linkage)
651E and 657E Wheel Tractor-Scrapers Hydraulic System Ejector Valve (Speed Change) - If Equipped
988G Wheel Loader Engine Supplement Engine Oil Cooler - Install - Engine In Chassis
2000/08/14 A New Relief Valve for the Gear Motor (Fan Drive) Improves the Accuracy of Fan Speed {5069}
910G HYSTAT Wheel Loader Cab Door
3003, 3013, 3014 and 3024 Engines for Caterpillar Built Machines Engine Valve Lash - Inspect/Adjust
994D Wheel Loader Battery - Clean
651E and 657E Wheel Tractor-Scrapers Air System and Brakes Solenoid Valve (Apron)
988G Wheel Loader Engine Supplement Engine Oil Cooler - Remove - Engine In Chassis
988G Wheel Loader Engine Supplement Engine to Torque Converter - Connect
988G Wheel Loader Engine Supplement Engine from Torque Converter - Separate
651E and 657E Wheel Tractor-Scrapers Air System and Brakes General Information
3524B Engines for Off-Highway Trucks Excessive Black Smoke
963B Track-Type Loader Engine Valve Lash - Check
980G Wheel Loader Steering System Relief Valve (Steering Cylinder Crossover) - Test and Adjust
651E and 657E Wheel Tractor-Scrapers Hydraulic System Sequence and Pressure Control Valve (Apron)
3064 and 3066 Engines for Caterpillar Built Machines Cooling System - Inspect
3054 Engine Cooling System - Test
2000/03/27 Correct Identification of Cutting Edges for Bucket Arrangements {6101, 6103, 6104, 6105, 6139, 6801}
988G Wheel Loader Machine Systems Gear Motor (Hydraulic Fan) - Remove
988G Wheel Loader Machine Systems Gear Motor (Hydraulic Fan) - Install
651E and 657E Wheel Tractor-Scrapers Air System and Brakes Air Compressor
988G Wheel Loader Machine Systems Piston Pump (Hydraulic Fan) - Disassemble