Starting Above 0°C (32°F)
- Move the direction control lever into NEUTRAL.
- Move the control levers to the HOLD position.
- Turn the engine start switch to the ON position (1).
Show/hide table
Illustration 1 | g00689006 |
- Turn the engine start switch key to the START position (2) in order to start the engine. Release the key when the engine starts.
Show/hide table
NOTICE |
---|
Do not crank the engine for more than 30 seconds. Allow the starter to cool for two minutes before cranking again. Turbocharger (if equipped) damage can result, if the engine is not kept low until the engine oil light/gauge verifies the oil pressure is sufficient. |
Caterpillar Information System:
988G Wheel Loader Electrohydraulic System Position Sensor (Lift Linkage and Tilt Linkage)
651E and 657E Wheel Tractor-Scrapers Hydraulic System Ejector Valve (Speed Change) - If Equipped
988G Wheel Loader Engine Supplement Engine Oil Cooler - Install - Engine In Chassis
2000/08/14 A New Relief Valve for the Gear Motor (Fan Drive) Improves the Accuracy of Fan Speed {5069}
910G HYSTAT Wheel Loader Cab Door
3003, 3013, 3014 and 3024 Engines for Caterpillar Built Machines Engine Valve Lash - Inspect/Adjust
994D Wheel Loader Battery - Clean
651E and 657E Wheel Tractor-Scrapers Air System and Brakes Solenoid Valve (Apron)
988G Wheel Loader Engine Supplement Engine Oil Cooler - Remove - Engine In Chassis
988G Wheel Loader Engine Supplement Engine to Torque Converter - Connect
988G Wheel Loader Engine Supplement Engine from Torque Converter - Separate
3003, 3013, 3014 and 3024 Engines for Caterpillar Built Machines Finding Top Center Position for No. 1 Piston
910G HYSTAT Wheel Loader Starting Below 0°C (32°F) with Thermal Starting Aid
651E and 657E Wheel Tractor-Scrapers Air System and Brakes General Information
3524B Engines for Off-Highway Trucks Excessive Black Smoke
963B Track-Type Loader Engine Valve Lash - Check
980G Wheel Loader Steering System Relief Valve (Steering Cylinder Crossover) - Test and Adjust
651E and 657E Wheel Tractor-Scrapers Hydraulic System Sequence and Pressure Control Valve (Apron)
3064 and 3066 Engines for Caterpillar Built Machines Cooling System - Inspect
3054 Engine Cooling System - Test
2000/03/27 Correct Identification of Cutting Edges for Bucket Arrangements {6101, 6103, 6104, 6105, 6139, 6801}
988G Wheel Loader Machine Systems Gear Motor (Hydraulic Fan) - Remove
988G Wheel Loader Machine Systems Gear Motor (Hydraulic Fan) - Install
651E and 657E Wheel Tractor-Scrapers Air System and Brakes Air Compressor