Engine Oil Cooler - Install - Engine In Chassis
Installation Procedure
- Install two O-ring seals (5) and (6) .
Show/hide table
Illustration 1 | g00688881 |
Note: Lubricate the O-ring seals slightly with clean engine oil prior to assembly.
- Install two O-ring seals to the adapter (not shown). Lightly lubricate the bore for the engine oil cooler and the O-ring seals with glycerin. Install the adapter to the engine oil cooler (not shown).
- Install engine oil cooler (5) and two bolts (4) .
Show/hide table
Illustration 2 | g00688879 |
- Install bolt (3) .
Show/hide table
Illustration 3 | g00688876 |
- Install the O-ring seal onto the bonnet (not shown). Lightly lubricate the O-ring seal with glycerin.
Show/hide table
Illustration 4 | g00688874 |
- Install bonnet (1) and bolt (2) .
- Fill the engine crankcase with oil. Refer to the appropriate Operation and Maintenance Manual for the correct procedure.
End By: Install the transmission oil cooler. Refer to Disassembly and Assembly, "Transmission Oil Cooler - Install".
Caterpillar Information System:
2000/08/14 A New Relief Valve for the Gear Motor (Fan Drive) Improves the Accuracy of Fan Speed {5069}
910G HYSTAT Wheel Loader Cab Door
3003, 3013, 3014 and 3024 Engines for Caterpillar Built Machines Engine Valve Lash - Inspect/Adjust
994D Wheel Loader Battery - Clean
651E and 657E Wheel Tractor-Scrapers Air System and Brakes Solenoid Valve (Apron)
988G Wheel Loader Engine Supplement Engine Oil Cooler - Remove - Engine In Chassis
988G Wheel Loader Engine Supplement Engine to Torque Converter - Connect
988G Wheel Loader Engine Supplement Engine from Torque Converter - Separate
3003, 3013, 3014 and 3024 Engines for Caterpillar Built Machines Finding Top Center Position for No. 1 Piston
2000/03/27 A Stronger Carrier Roller Mounting Bracket Improves Reliability {4154}
3003, 3013, 3014 and 3024 Engines for Caterpillar Built Machines Fuel System - Prime
545 Wheel Skidder Refrigerant Accumulator (With Desiccant) - Replace
651E and 657E Wheel Tractor-Scrapers Hydraulic System Ejector Valve (Speed Change) - If Equipped
988G Wheel Loader Electrohydraulic System Position Sensor (Lift Linkage and Tilt Linkage)
910G HYSTAT Wheel Loader Starting Above 0°C (32°F)
910G HYSTAT Wheel Loader Starting Below 0°C (32°F) with Thermal Starting Aid
651E and 657E Wheel Tractor-Scrapers Air System and Brakes General Information
3524B Engines for Off-Highway Trucks Excessive Black Smoke
963B Track-Type Loader Engine Valve Lash - Check
980G Wheel Loader Steering System Relief Valve (Steering Cylinder Crossover) - Test and Adjust
651E and 657E Wheel Tractor-Scrapers Hydraulic System Sequence and Pressure Control Valve (Apron)
3064 and 3066 Engines for Caterpillar Built Machines Cooling System - Inspect
3054 Engine Cooling System - Test
2000/03/27 Correct Identification of Cutting Edges for Bucket Arrangements {6101, 6103, 6104, 6105, 6139, 6801}