Engine Valve Lash - Check
Refer to Systems Operation, Testing and Adjusting, SENR3583, "3114, 3116 and 3126 Engines" for the correct procedures when you check engine valve lash and/or fuel injector timing.
Note: Make sure that qualified service personnel check the injector fuel timing. If an adjustment is necessary, make sure that qualified service personnel adjust the injector fuel timing. Special tools and training are required.
Note: The correct fuel timing specification is shown on the Engine Information Plate. Fuel timing specifications will be different with each engine application and with each power rating.
Consult your Caterpillar dealer for the complete adjustment procedure.
Caterpillar Information System:
3524B Engines for Off-Highway Trucks Excessive Black Smoke
651E and 657E Wheel Tractor-Scrapers Air System and Brakes General Information
910G HYSTAT Wheel Loader Starting Below 0°C (32°F) with Thermal Starting Aid
910G HYSTAT Wheel Loader Starting Above 0°C (32°F)
988G Wheel Loader Electrohydraulic System Position Sensor (Lift Linkage and Tilt Linkage)
651E and 657E Wheel Tractor-Scrapers Hydraulic System Ejector Valve (Speed Change) - If Equipped
988G Wheel Loader Engine Supplement Engine Oil Cooler - Install - Engine In Chassis
2000/08/14 A New Relief Valve for the Gear Motor (Fan Drive) Improves the Accuracy of Fan Speed {5069}
910G HYSTAT Wheel Loader Cab Door
3003, 3013, 3014 and 3024 Engines for Caterpillar Built Machines Engine Valve Lash - Inspect/Adjust
994D Wheel Loader Battery - Clean
651E and 657E Wheel Tractor-Scrapers Air System and Brakes Solenoid Valve (Apron)
980G Wheel Loader Steering System Relief Valve (Steering Cylinder Crossover) - Test and Adjust
651E and 657E Wheel Tractor-Scrapers Hydraulic System Sequence and Pressure Control Valve (Apron)
3064 and 3066 Engines for Caterpillar Built Machines Cooling System - Inspect
3054 Engine Cooling System - Test
2000/03/27 Correct Identification of Cutting Edges for Bucket Arrangements {6101, 6103, 6104, 6105, 6139, 6801}
988G Wheel Loader Machine Systems Gear Motor (Hydraulic Fan) - Remove
988G Wheel Loader Machine Systems Gear Motor (Hydraulic Fan) - Install
651E and 657E Wheel Tractor-Scrapers Air System and Brakes Air Compressor
988G Wheel Loader Machine Systems Piston Pump (Hydraulic Fan) - Disassemble
988G Wheel Loader Machine Systems Piston Pump (Hydraulic Fan) - Assemble
3064 and 3066 Engines for Caterpillar Built Machines Cooling System - Check - Overheating
2000/03/27 Procedure to Enter the Correct Password for the Calibration Procedure on the Payload Control System (PCS) {7494}