Stopping the Engine
Show/hide table
NOTICE |
---|
Stopping the engine immediately after it has been working under load can result in overheating and accelerated wear of the engine components. Refer to the following stopping procedure, to allow the engine to cool, and to prevent excessive temperatures in the turbocharger center housing, (if equipped) which could cause oil coking problems. |
- While the machine is stopped, run the engine for five minutes at LOW IDLE.
- Turn the start switch key to OFF. Remove the key.
Show/hide table
Illustration 1 | g00529967 |
Long Term Idle
Idle the machine at an engine RPM that is slightly higher than the LOW IDLE. Idling at the higher engine RPM ensures good lubrication.
Caterpillar Information System:
515 Wheel Skidder and 525 Wheel Skidder Transmission and Grapple Electronic Control System Start Relay
623F Wheel Tractor-Scraper Power Train Retarder Hydraulic Control Valve - Assemble
515 Wheel Skidder and 525 Wheel Skidder Transmission and Grapple Electronic Control System Start Switch (Key)
545 Wheel Skidder Hydraulic and Steering System Steering Cylinder
994D Air System Wheel Loader Air Dryer - Check
623F Wheel Tractor-Scraper Power Train Retarder Hydraulic Control Valve - Disassemble
3046 Engine For Caterpillar Built Machines Housing (Front) - Install
D9R Track-Type Tractor Machine Systems Refrigerant Condenser - Remove and Install
D9R Track-Type Tractor Machine Systems Refrigerant Compressor - Remove and Install
D9R Track-Type Tractor Machine Systems Air Conditioner Dryer - Remove and Install
D9R Track-Type Tractor Machine Systems Air Conditioner and Heater Fan Motor - Remove and Install
D9R Track-Type Tractor Machine Systems Rollover Protective Structure (ROPS) - Remove and Install
963B Track-Type Loader Engine Oil and Filter - Change
D9R Track-Type Tractor Machine Systems Refrigerant Accumulator - Remove and Install
D9R Track-Type Tractor Engine Air Filter Primary Element - Clean/Replace
D9R Track-Type Tractor Machine Systems Refrigerant Evaporator Core and Heater Core - Remove and Install
D9R Track-Type Tractor Machine Systems Steering Pump - Assemble
515 Wheel Skidder and 525 Wheel Skidder Caterpillar Monitoring System
980G Wheel Loader Power Train Limited Slip Differential - Assemble
D9R Track-Type Tractor Machine Systems Steering Pump - Disassemble
D9R Track-Type Tractor Machine Systems Steering Pump - Install
D9R Track-Type Tractor Machine Systems Steering Pump - Remove
963B Track-Type Loader Hydraulic System Tilt Circuit
D9R Track-Type Tractor Machine Systems Implement Pump - Assemble