Hydraulic System Oil Sample - Obtain
Show/hide table
Illustration 1 | g00528662 |
The hydraulic system is not equipped with an oil sampling valve. Obtaining an oil sample will require a vacuum pump or the equivalent in order to withdraw the oil from the hydraulic tank.
Operate the machine and the hydraulic controls for a few minutes before you obtain the oil sample. This will thoroughly mix the hydraulic oil for a more accurate sample. Slowly remove the hydraulic tank filler cap in order to relieve any pressure. Withdraw the oil through the hydraulic oil filler tube.
Reference: Refer to Operation and Maintenance Manual, "S·O·S Oil Analysis" and to Special Publication, PEHP6001, "How To Take A Good Oil Sample" for information about obtaining a sample of the hydraulic system oil.
Caterpillar Information System:
515 Wheel Skidder and 525 Wheel Skidder Transmission and Grapple Electronic Control System Electrical Connector - Inspect
963B Track-Type Loader Radiator Pressure Cap - Clean/Replace
D9R Track-Type Tractor Steering Clutch and Brake Control
3046 Engine For Caterpillar Built Machines Vibration Damper and Pulley - Remove and Install
515 Wheel Skidder and 525 Wheel Skidder Hydraulic System Oil Filter - Replace
515 Wheel Skidder and 525 Wheel Skidder Transmission and Grapple Electronic Control System Glossary of Electrical Terms
963B Track-Type Loader Bucket Teeth and Cutting Edges - Inspect/Replace
994D Air System Wheel Loader Air Starting System
515 Wheel Skidder and 525 Wheel Skidder Hydraulic System Oil - Change
994D Air System Wheel Loader Control Valve (Air Tank Drain)
980G Wheel Loader Machine Systems Blower Motor (Air Conditioner, Heater) - Remove and Install
515 Wheel Skidder and 525 Wheel Skidder Hydraulic System Oil Level - Check
515 Wheel Skidder and 525 Wheel Skidder Transmission and Grapple Electronic Control System System Schematic
611 Wheel Tractor-Scraper Cooling System Pressure Cap - Clean/Replace
515 Wheel Skidder and 525 Wheel Skidder Engine Oil Level - Check
980G Wheel Loader Machine Systems Gear Pump (Hydraulic Fan) - Assemble
545 Wheel Skidder Hydraulic and Steering System Lift Cylinder (Decking Blade)
G3500B Engines Emergency Stopping
963B Track-Type Loader Cab Air Filter - Clean/Replace
623F Wheel Tractor-Scraper Machine Systems Steering Link - Remove and Install
515 Wheel Skidder and 525 Wheel Skidder Engine Oil and Filter - Change
D9R Track-Type Tractor Starting Above 0°C (32°F)
623F Wheel Tractor-Scraper Power Train Transfer Gears - Disassemble
623F Wheel Tractor-Scraper Power Train Transfer Gears - Assemble