Hydraulic System Oil Filter - Replace
- Lower all attachments to the ground. Apply the parking brake and stop the engine.
- Open the access door on the top of the engine enclosure.
Show/hide table
Illustration 1 | g00527460 |
- Slowly loosen hydraulic tank filler cap (1) in order to release the pressure from the tank.
Show/hide table
Illustration 2 | g00528788 |
- Remove the four bolts and cover (2) on the top of the hydraulic oil filter.
- Clean the cover. If the cover seal is damaged, replace the seal.
- Remove the filter element. Dispose of the used element properly.
- Install a new filter element.
- Install cover (2) and the bolts. Tighten the bolts to a torque of 55 ± 10 N·m (41 ± 7 lb ft).
- Tighten hydraulic tank filler cap (1) .
- Start the engine and operate the brakes, the steering and the attachments. Check the hydraulic oil level.
Reference: Refer to Operation and Maintenance Manual, "Hydraulic System Oil Level - Check" for the correct procedure.
Caterpillar Information System:
515 Wheel Skidder and 525 Wheel Skidder Transmission and Grapple Electronic Control System Glossary of Electrical Terms
963B Track-Type Loader Bucket Teeth and Cutting Edges - Inspect/Replace
994D Air System Wheel Loader Air Starting System
515 Wheel Skidder and 525 Wheel Skidder Hydraulic System Oil - Change
994D Air System Wheel Loader Control Valve (Air Tank Drain)
980G Wheel Loader Machine Systems Blower Motor (Air Conditioner, Heater) - Remove and Install
515 Wheel Skidder and 525 Wheel Skidder Hydraulic System Oil Level - Check
623F Wheel Tractor-Scraper Hydraulic System Floor Cylinder
623F Wheel Tractor-Scraper Power Train Torque Converter - Assemble
994D Air System Wheel Loader Relief Valve (Air Tank)
994D Air System Wheel Loader Solenoid Valve (Air Horn)
980G Wheel Loader Machine Systems Pilot Valve (Oil Manifold) - Assemble
3046 Engine For Caterpillar Built Machines Vibration Damper and Pulley - Remove and Install
D9R Track-Type Tractor Steering Clutch and Brake Control
963B Track-Type Loader Radiator Pressure Cap - Clean/Replace
515 Wheel Skidder and 525 Wheel Skidder Transmission and Grapple Electronic Control System Electrical Connector - Inspect
515 Wheel Skidder and 525 Wheel Skidder Hydraulic System Oil Sample - Obtain
515 Wheel Skidder and 525 Wheel Skidder Transmission and Grapple Electronic Control System System Schematic
611 Wheel Tractor-Scraper Cooling System Pressure Cap - Clean/Replace
515 Wheel Skidder and 525 Wheel Skidder Engine Oil Level - Check
980G Wheel Loader Machine Systems Gear Pump (Hydraulic Fan) - Assemble
545 Wheel Skidder Hydraulic and Steering System Lift Cylinder (Decking Blade)
G3500B Engines Emergency Stopping
963B Track-Type Loader Cab Air Filter - Clean/Replace