Bucket Teeth and Cutting Edges - Inspect/Replace
Show/hide table
 |
Personal injury or death can result from bucket falling. Block the bucket before changing bucket tips. |
 |
- Raise the bucket and block up the bucket. Only block up the bucket to a sufficient height for removing the bucket tips.
- Shut off the engine.
- Drive the pin out of the bucket tip from the retainer side of the bucket tip. Remove the bucket tip and the retainer.
Show/hide table
 | |
| Illustration 1 | g00528688 |
- Clean the adapter, the pin, and the retainer. Install the retainer in the groove.
- Install a new bucket tip over the retainer in the runner position or in the digger position.
- Drive the pin through the retainer, through the adapter, and through the bucket tip from the opposite side of the retainer.
- To change the cutting edges, remove the two bolts and two nuts. Then, remove the cutting edge.
- Install the new cutting edge, the two bolts and two nuts.
- Start the engine.
- Raise the bucket and remove the supporting block. Lower the bucket to the ground.
Caterpillar Information System:
994D Air System Wheel Loader Air Starting System
515 Wheel Skidder and 525 Wheel Skidder Hydraulic System Oil - Change
994D Air System Wheel Loader Control Valve (Air Tank Drain)
980G Wheel Loader Machine Systems Blower Motor (Air Conditioner, Heater) - Remove and Install
515 Wheel Skidder and 525 Wheel Skidder Hydraulic System Oil Level - Check
623F Wheel Tractor-Scraper Hydraulic System Floor Cylinder
623F Wheel Tractor-Scraper Power Train Torque Converter - Assemble
994D Air System Wheel Loader Relief Valve (Air Tank)
994D Air System Wheel Loader Solenoid Valve (Air Horn)
980G Wheel Loader Machine Systems Pilot Valve (Oil Manifold) - Assemble
994D Air System Wheel Loader Solenoid Valve (Automatic Lubrication)
3516B Engine for Caterpillar Built Machines Customer Parameters Worksheet
515 Wheel Skidder and 525 Wheel Skidder Transmission and Grapple Electronic Control System Glossary of Electrical Terms
515 Wheel Skidder and 525 Wheel Skidder Hydraulic System Oil Filter - Replace
3046 Engine For Caterpillar Built Machines Vibration Damper and Pulley - Remove and Install
D9R Track-Type Tractor Steering Clutch and Brake Control
963B Track-Type Loader Radiator Pressure Cap - Clean/Replace
515 Wheel Skidder and 525 Wheel Skidder Transmission and Grapple Electronic Control System Electrical Connector - Inspect
515 Wheel Skidder and 525 Wheel Skidder Hydraulic System Oil Sample - Obtain
515 Wheel Skidder and 525 Wheel Skidder Transmission and Grapple Electronic Control System System Schematic
611 Wheel Tractor-Scraper Cooling System Pressure Cap - Clean/Replace
515 Wheel Skidder and 525 Wheel Skidder Engine Oil Level - Check
980G Wheel Loader Machine Systems Gear Pump (Hydraulic Fan) - Assemble
545 Wheel Skidder Hydraulic and Steering System Lift Cylinder (Decking Blade)