980G Wheel Loader Machine Systems Caterpillar

Assembly Procedure

Note: Cleanliness is an important factor. Before assembly, all parts should be thoroughly cleaned in cleaning fluid. Allow the parts to air dry. Wiping cloths or rags should not be used to dry parts. Lint may be deposited on the parts which may cause later trouble. Inspect all parts. If any parts are worn or damaged, use new parts for replacement.

Show/hide table



Illustration 1	g00528811

1. Check the condition of the components of seal kit (10). If any components are worn or damaged, use a new seal kit for replacement.

2. Install seal (2) in flange (3) .

3. Assemble cover (6), two gear assemblies (5), four dowels (4), and seal kit (10) on flange (3) .

4. Install four bolts (8) .

5. Install snap ring (1) .

6. Install two plugs (9). Tighten the plugs to a torque of 183 ± 14 N·m (135 ± 10 lb ft).

7. Install relief valve (7). Tighten the relief valve to a torque of 47.5 N·m (35 lb ft).

End By: Install the gear pump. Refer to Disassembly and Assembly, "Gear Pump (Hydraulic Fan) - Install".