Flywheel - Install
Installation Procedure
Show/hide table
Required Tools     | |||
---|---|---|---|
Tool     | Part Number     | Part Description     | Qty     |
A     | 138-7575     | Link Bracket     | 1     |
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
Show/hide table
Always wear protective gloves when handling parts that have been heated. |
- Use an oven and heat ring gear (2) to a maximum temperature of 150 °C (302 °F). Install the ring gear.
- Position the ring gear (4) on flywheel (2) .
Show/hide table
Illustration 1 | g00562859 |
- Check the condition of the dowels (not shown). If the dowels are damaged, use new parts for replacement.
Show/hide table
Illustration 2 | g00527024 |
- Install Tool (A), a strap, and a suitable lifting device onto flywheel (2) .
- Install flywheel (2). The weight of the flywheel is 50 kg (110 lb).
Note: Dowel pin hole (3) is slightly offset in order to ensure correct installation.
- Install six bolts (1) in order to secure flywheel (2) onto the crankshaft. Tighten the bolts to a torque of 83 ± 5 N·m (61 ± 4 lb ft).
- Remove Tool (A) .
- Check the flywheel runout. Refer to Testing and Adjusting, "Flywheel - Inspect" for more information on flywheel runout.
Caterpillar Information System:
980G Wheel Loader Machine Systems Heater Coil - Remove and Install
631E Series II and 637E Series II Wheel Tractor-Scrapers Auger Hydraulic System Auger Drive - Test and Adjust
623F Wheel Tractor-Scraper Machine Systems Steering Cylinder - Install
623F Wheel Tractor-Scraper Machine Systems Steering Cylinder - Remove
D8R Track-Type Tractor Engine Supplement Engine Oil Filter and Base - Remove and Install
D8R Track-Type Tractor Engine Supplement Water Temperature Regulator - Remove and Install
D8R Track-Type Tractor Engine Supplement Crankshaft Vibration Damper - Remove and Install
D8R Track-Type Tractor Engine Supplement Fuel Shutoff Solenoid - Remove and Install
D8R Track-Type Tractor Engine Supplement Belt Tightener - Install
D8R Track-Type Tractor Engine Supplement Belt Tightener - Remove
D8R Track-Type Tractor Engine Supplement Fan Drive - Install
D8R Track-Type Tractor Engine Supplement Fan Drive - Remove
3064 and 3066 Engines for Caterpillar Built Machines Gear Group (Front)
824G Wheel Dozer, 825G Soil Compactor and 826G Landfill Compactor Hydraulic System Hydraulic Electronic Control (Joystick)
994D Air System Wheel Loader Air Dryer
D9R Track-Type Tractor Ether Starting Aid
D9R Track-Type Tractor Caterpillar Monitoring System
3064 and 3066 Engines for Caterpillar Built Machines Camshaft
3046 Engine For Caterpillar Built Machines Crankshaft Rear Seal - Remove
994D Air System Wheel Loader General Information
D9R Track-Type Tractor Gauges
515 Wheel Skidder and 525 Wheel Skidder Cooling System Level - Check
994D Air System Wheel Loader Air Horn
D9R Track-Type Tractor Digital Display Window