Connecting Rod Bearings - Remove
Removal Procedure
Start By:
- Remove the engine oil pan. Refer to Disassembly and Assembly, "Engine Oil Pan - Remove and Install".
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Remove the suction bell assembly.
Show/hide table
Illustration 1 | g01011732 |
- Inspect the connecting rod and connecting rod cap (1) for the proper identification mark. The connecting rod and connecting rod cap (1) should have an etched number on the side that is toward the right side of the engine. The number should match the cylinder number. The bearing retainer notch should also be on the right side. Mark the connecting rod and connecting rod cap (1), if necessary.
- Remove the connecting rod cap bolts and connecting rod cap (1) .
- Remove the lower half of the connecting rod bearing (2) from connecting rod cap (1) .
- Push the connecting rod away from the crankshaft. Remove the upper half of connecting rod bearing.
Caterpillar Information System:
C12 Marine Engines Pistons and Connecting Rods - Install
C12 Marine Engines Pistons and Connecting Rods - Assemble
2004/11/01 New UPS System Controller Boards Are Now Available {1418}
C12 Marine Engines Pistons and Connecting Rods - Disassemble
C12 Marine Engines Pistons and Connecting Rods - Remove
C12 Marine Engines Cylinder Liner - Install
C12 Marine Engines Cylinder Liner - Remove
C12 Marine Engines Engine Oil Pan - Remove and Install
C12 Marine Engines Camshaft - Install
C12 Marine Engines Camshaft - Remove
C12 Marine Engines Front Cover - Install
C12 Marine Engines Front Cover - Remove
C12 Marine Engines Connecting Rod Bearings - Install
C12 Marine Engines Crankshaft Main Bearings - Remove
C11 and C13 Engines for Caterpillar Built Machines Can Not Reach Top Engine RPM
C12 Marine Engines Crankshaft Main Bearings - Install
C12 Marine Engines Crankshaft - Remove
C9 Industrial Engines Electric Starting Motor
C12 Marine Engines Crankshaft - Install
C12 Marine Engines Crankshaft Gear - Remove and Install
C9 Industrial Engines Jacket Water Heater
G3520C and G3520E Engines Thermostatic Valve
Cat® Digital Voltage Regulator Parameter Viewing and Configuration (Caterpillar Electronic Technician)
C9 Generator Set Engines Electronic Control Module