Crankshaft Main Bearings - Remove
Removal Procedure
Show/hide table
Required Tools     | |||
Tool     | Part Number     | Part Description     | Qty     |
A     | 2P-5518     | Bearing Tool     | 1     |
Start By:
- Remove the engine oil pan. Refer to Disassembly and Assembly, "Engine Oil Pan - Remove and Install".
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Remove crankshaft main bearing cap (1) .
Show/hide table
Illustration 1 | g01011713 |
- Remove the lower half of crankshaft main bearing (2) from crankshaft main bearing cap (1) .
- Install Tooling (A) into the crankshaft journal.
Show/hide table
Illustration 2 | g01011722 |
Show/hide table
NOTICE |
---|
If the crankshaft is turned in the wrong direction, the tab of the crankshaft main bearing will be pushed between the crankshaft and the cylinder block. this can cause damage to either or both the crankshaft and the cylinder block. |
- Turn the crankshaft in order to remove the upper half of crankshaft main bearing (2) .
- Check the condition of the crankshaft main bearings. Refer to the Guideline For Reusable Parts, SEBF8009, "Main and Connecting Rod Bearings" or refer to the Guideline For Reusable Parts, SEBV0544, "Engine Bearings and Crankshafts".
- Remove thrust plate (3) .
Caterpillar Information System:
C12 Marine Engines Connecting Rod Bearings - Install
C12 Marine Engines Connecting Rod Bearings - Remove
C12 Marine Engines Pistons and Connecting Rods - Install
C12 Marine Engines Pistons and Connecting Rods - Assemble
2004/11/01 New UPS System Controller Boards Are Now Available {1418}
C12 Marine Engines Pistons and Connecting Rods - Disassemble
C12 Marine Engines Pistons and Connecting Rods - Remove
C12 Marine Engines Cylinder Liner - Install
C12 Marine Engines Cylinder Liner - Remove
C12 Marine Engines Engine Oil Pan - Remove and Install
C12 Marine Engines Camshaft - Install
C12 Marine Engines Camshaft - Remove
C11 and C13 Engines for Caterpillar Built Machines Can Not Reach Top Engine RPM
C12 Marine Engines Crankshaft Main Bearings - Install
C12 Marine Engines Crankshaft - Remove
C9 Industrial Engines Electric Starting Motor
C12 Marine Engines Crankshaft - Install
C12 Marine Engines Crankshaft Gear - Remove and Install
C9 Industrial Engines Jacket Water Heater
G3520C and G3520E Engines Thermostatic Valve
Cat® Digital Voltage Regulator Parameter Viewing and Configuration (Caterpillar Electronic Technician)
C9 Generator Set Engines Electronic Control Module
C12 Marine Engines Electronic Control Module - Remove and Install
2004/11/01 Improved Turbocharger {1052}