Crankshaft Gear - Remove and Install
Removal Procedure
Show/hide table
Required Tools     | |||
Tool     | Part Number     | Part Description     | Qty     |
A     | 1U-6400     | Three Jaw Puller     | 1     |
Start By:
- Remove the crankshaft. Refer to Disassembly and Assembly, "Crankshaft - Remove".
- Use Tooling (A) in order to remove crankshaft gear (2) from crankshaft (1) .
Show/hide table
Illustration 1 | g01022856 |
- Remove drive pin (3) .
Installation Procedure
Show/hide table
Required Tools     | |||
Tool     | Part Number     | Part Description     | Qty     |
B     | 6V-2098     | Press Sleeve     | 1     |
C     | 8H-8581     | Gauge     | 1     |
- Install drive pin (3) .
Show/hide table
Illustration 2 | g01066237 |
- Raise the temperature of crankshaft gear (2) .
Show/hide table
Always wear protective gloves when handling parts that have been heated. |
- Install crankshaft gear (2) on the end of crankshaft (1). Ensure that the slot in crankshaft gear (2) is aligned with drive pin (3) .
- Use Tooling (B) in order to seat crankshaft gear (2) against the shoulder of crankshaft (1) .
Show/hide table
Illustration 3 | g01066239 |
- Use Tooling (C) in order to ensure that crankshaft gear (2) is seated against the shoulder on the crankshaft.
Note: Check the crankshaft gear in three places with Tooling (C) .
End By: Install the crankshaft. Refer to Disassembly and Assembly, "Crankshaft - Install".
Caterpillar Information System:
C12 Marine Engines Crankshaft - Install
C9 Industrial Engines Electric Starting Motor
C12 Marine Engines Crankshaft - Remove
C12 Marine Engines Crankshaft Main Bearings - Install
C11 and C13 Engines for Caterpillar Built Machines Can Not Reach Top Engine RPM
C12 Marine Engines Crankshaft Main Bearings - Remove
C12 Marine Engines Connecting Rod Bearings - Install
C12 Marine Engines Connecting Rod Bearings - Remove
C12 Marine Engines Pistons and Connecting Rods - Install
C12 Marine Engines Pistons and Connecting Rods - Assemble
2004/11/01 New UPS System Controller Boards Are Now Available {1418}
C12 Marine Engines Pistons and Connecting Rods - Disassemble
C9 Industrial Engines Jacket Water Heater
G3520C and G3520E Engines Thermostatic Valve
Cat® Digital Voltage Regulator Parameter Viewing and Configuration (Caterpillar Electronic Technician)
C9 Generator Set Engines Electronic Control Module
C12 Marine Engines Electronic Control Module - Remove and Install
2004/11/01 Improved Turbocharger {1052}
C12 Marine Engines Alternator - Remove and Install
3054 and 3056 Marine Generator Sets Maintenance Interval Schedule - 3054 Naturally Aspirated Marine Generator Set Engine
C12 Marine Engines Electric Starting Motor - Remove and Install
EMCP3 System Operation
C12 Marine Engines Engine Oil Filter Base - Remove
C12 Marine Engines Engine Oil Filter Base - Install