Crankshaft - Remove
Removal Procedure
Show/hide table
Required Tools     | |||
Tool     | Part Number     | Part Description     | Qty     |
A     | 138-7574     | Link Bracket     | 2     |
Start By:
- Remove the front housing. Refer to Disassembly and Assembly, "Housing (Front) - Remove".
- Remove the flywheel housing. Refer to Disassembly and Assembly, "Flywheel Housing - Remove and Install".
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Remove connecting rod caps (2) and connecting rod bearings (1) .
Show/hide table
Illustration 1 | g01108128 |
Note: Place an identification mark on all connecting rod caps (2). Connecting rod caps (2) should be marked with the corresponding cylinder number.
- Remove crankshaft main bearing caps (4) and crankshaft main bearings (5) .
Note: Crankshaft main bearing caps (4) are marked with the numbers 1 through 7. Crankshaft main bearing caps (4) that are not marked should be marked with the corresponding cylinder number on the side that is toward the right side of the engine.
- Remove crankshaft thrust bearings (3) .
- Attach Tooling (A) and a suitable lifting device to crankshaft (6). The weight of the crankshaft is approximately 180 kg (400 lb).
- Remove crankshaft (6) .
Caterpillar Information System:
C12 Marine Engines Crankshaft Main Bearings - Install
C11 and C13 Engines for Caterpillar Built Machines Can Not Reach Top Engine RPM
C12 Marine Engines Crankshaft Main Bearings - Remove
C12 Marine Engines Connecting Rod Bearings - Install
C12 Marine Engines Connecting Rod Bearings - Remove
C12 Marine Engines Pistons and Connecting Rods - Install
C12 Marine Engines Pistons and Connecting Rods - Assemble
2004/11/01 New UPS System Controller Boards Are Now Available {1418}
C12 Marine Engines Pistons and Connecting Rods - Disassemble
C12 Marine Engines Pistons and Connecting Rods - Remove
C12 Marine Engines Cylinder Liner - Install
C12 Marine Engines Cylinder Liner - Remove
C9 Industrial Engines Electric Starting Motor
C12 Marine Engines Crankshaft - Install
C12 Marine Engines Crankshaft Gear - Remove and Install
C9 Industrial Engines Jacket Water Heater
G3520C and G3520E Engines Thermostatic Valve
Cat® Digital Voltage Regulator Parameter Viewing and Configuration (Caterpillar Electronic Technician)
C9 Generator Set Engines Electronic Control Module
C12 Marine Engines Electronic Control Module - Remove and Install
2004/11/01 Improved Turbocharger {1052}
C12 Marine Engines Alternator - Remove and Install
3054 and 3056 Marine Generator Sets Maintenance Interval Schedule - 3054 Naturally Aspirated Marine Generator Set Engine
C12 Marine Engines Electric Starting Motor - Remove and Install