Alternator Belt - Remove and Install
Remove the Alternator Belt
Show/hide table
Illustration 1 | g00451964 |
- Remove four bolts (1) and six bolts (2) . Remove fan shroud (3) .
- Remove six bolts (5) and lay fan (4) against the radiator.
Note: Use care when you are laying the fan against the radiator in order to prevent damage to the radiator.
Show/hide table
Illustration 2 | g00451966 |
- Loosen bolt (7) .
Show/hide table
Illustration 3 | g00451967 |
- Loosen nut (6) in order to relieve the tension on alternator belt (8) . Remove alternator belt (8) .
Install the Alternator Belt
- Replace alternator belt (8) . Adjust tension on alternator belt (8) . Tighten nut (6) .
Note: Refer to Operation and Maintenance Manual, SEBU7115-01, "Alternator and Fan Belts - Inspect/Adjust/Replace" for the correct belt tension.
Show/hide table
Illustration 4 | g00451967 |
- Tighten bolt (7) .
- Put fan (4) into position and install six bolts (5) .
Show/hide table
Illustration 5 | g00451966 |
- Put fan shroud (3) into position and install six bolts (2) and four bolts (1) .
Show/hide table
Illustration 6 | g00451964 |
Caterpillar Information System:
994D Wheel Loader Engine Oil and Filter - Change
928G Wheel Loader Tilt Cylinder Bearings and Bucket Linkage Bearings - Lubricate
994D Wheel Loader Engine Oil Level - Check
994D Wheel Loader Engine Mounts - Inspect
994D Wheel Loader Engine Crankcase Breather - Clean
994D Wheel Loader Engine Components - Replace/Install Reman
3116 Engine Supplement for 953C Track-Type Loader Alternator - Remove and Install
966G and 972G Wheel Loaders Power Train Differential and Bevel Gear - Remove
994D Wheel Loader Engine Components - Clean/Inspect, Rebuild/Install Reman, Install New
994D Wheel Loader Engine Air Precleaner - Clean
3116 Engine Supplement for 953C Track-Type Loader Air Inlet Heater - Remove and Install
994D Wheel Loader Engine Air Filter Secondary Element - Replace
966G and 972G Wheel Loaders Power Train Differential and Bevel Gear - Install
924Gz Wheel Loader Warranty Information
615C Series II Wheel Tractor-Scraper Machine Systems Hitch Bearings - Remove
615C Series II Wheel Tractor-Scraper Machine Systems Hitch Bearings - Install
994D Wheel Loader Ether Starting Aid Cylinder - Replace
615C Series II Wheel Tractor-Scraper Machine Systems Draft Frame Bearings - Remove and Install
950G Wheel Loader and 962G Wheel Loader Electrohydraulic System Lift Kickout Positioner - Adjust
950G and 962G Wheel Loaders and IT62G Integrated Toolcarrier Machine Systems Pilot Valve (Oil Manifold) - Disassemble
950G and 962G Wheel Loaders and IT62G Integrated Toolcarrier Machine Systems Pilot Valve (Oil Manifold) - Assemble
966G and 972G Wheel Loaders Power Train Heat Exchanger (Axle Oil Cooler) - Remove and Install
3304B and 3306B Engines for Caterpillar Built Machines Governor - Disassemble
994D Wheel Loader Fuel System - Prime