Alternator - Remove and Install
Remove the Alternator
Note: Mark all belts and wires for identification purposes.
Show/hide table
Illustration 1 | g00451715 |
- Disconnect wires (2) from the alternator.
- Remove the nut and wire clip (3) .
- Loosen nuts (1) and bolt (4) . Remove belts (5) from the pulley.
- Remove nuts (1) and bolt (4) . Remove the alternator mounting bolt and the alternator.
Show/hide table
Illustration 2 | g00451716 |
Install the Alternator
- Install the alternator and the alternator mounting bolt. Install nuts (1) and bolt (4) .
Show/hide table
Illustration 3 | g00451716 |
- Replace belts (5) on the pulley. Adjust tension on belts (5) . Tighten nuts (1) and bolt (4) .
Note: Refer to Operation and Maintenance Manual, SEBU7115-01, "Alternator and Fan Belts - Inspect/Adjust/Replace" for the correct belt tension. Measure the belt tension on the belt farthest from the engine block. If replacement of one belt in a belt set is necessary, replacement of the complete set is required.
Show/hide table
Illustration 4 | g00451715 |
- Replace the nut and wire clip (3) .
- Connect wires (2) to the alternator.
Caterpillar Information System:
966G and 972G Wheel Loaders Power Train Differential and Bevel Gear - Remove
994D Wheel Loader Engine Components - Clean/Inspect, Rebuild/Install Reman, Install New
994D Wheel Loader Engine Air Precleaner - Clean
3116 Engine Supplement for 953C Track-Type Loader Air Inlet Heater - Remove and Install
994D Wheel Loader Engine Air Filter Secondary Element - Replace
994D Wheel Loader Hydraulic System Hydraulic System Pressure - Release
615C Series II Wheel Tractor-Scraper Machine Systems Accumulator (Axle Suspension) - Install
928G Wheel Loader Steering Frame Lock
D8R Track-Type Tractor Cab Door
615C Series II Wheel Tractor-Scraper Machine Systems Accumulator (Axle Suspension) - Remove
994D Wheel Loader Engine Air Filter Primary Element - Clean/Replace
966G Wheel Loader and 972G Wheel Loader Machine Systems Steering Wheel - Remove and Install
994D Wheel Loader Engine Components - Replace/Install Reman
994D Wheel Loader Engine Crankcase Breather - Clean
994D Wheel Loader Engine Mounts - Inspect
994D Wheel Loader Engine Oil Level - Check
928G Wheel Loader Tilt Cylinder Bearings and Bucket Linkage Bearings - Lubricate
994D Wheel Loader Engine Oil and Filter - Change
3116 Engine Supplement for 953C Track-Type Loader Alternator Belt - Remove and Install
966G and 972G Wheel Loaders Power Train Differential and Bevel Gear - Install
924Gz Wheel Loader Warranty Information
615C Series II Wheel Tractor-Scraper Machine Systems Hitch Bearings - Remove
615C Series II Wheel Tractor-Scraper Machine Systems Hitch Bearings - Install
994D Wheel Loader Ether Starting Aid Cylinder - Replace