627F Wheel Tractor-Scraper Caterpillar

Stopping the Engine

Usage:

627F 1DL

Show/hide table

NOTICE

Stopping the engine immediately after it has been working under load can result in overheating and accelerated wear of the engine components. Refer to the following stopping procedure, to allow the engine to cool, and to prevent excessive temperatures in the turbocharger center housing, (if equipped) which could cause oil coking problems.

Note: Use the following procedure to stop the tractor engine.

Use the procedure that is described in Operation and Maintenance Manual, "Stopping the Machine" in order to stop the machine.
Run the engine at low idle for five minutes. Do not stop the engine immediately after the engine has been working under load.
Turn the engine start switch to the OFF position. Remove the engine start switch key.

Note: Use the following procedure to stop the scraper engine.

Stop the machine. Run the engine at low idle for five minutes. Do not stop the engine immediately after the engine has been working under load.
Show/hide table

Illustration 1 g00346869
Pull the governor control lever for the scraper engine toward the back of the machine to the FUEL-OFF position in order to shut off the engine. This lever is located near the battery disconnect switch. This switch is on the left side of the scraper engine.
Note: The governor control lever must be pushed forward to the FUEL-ON position in order to start the scraper engine.
Turn the engine start switch to the OFF position. This switch is located on the control panel for the scraper.
Remove the key.