Engine Oil Pressure Sensor - Remove and Install
Show/hide table
| NOTICE |
|---|
|
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to Special Publication, NENG2500, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat products. Dispose of all fluids according to local regulations and mandates. |
Show/hide table
| NOTICE |
|---|
|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Disconnect harness assembly (1).
- Remove engine oil pressure sensor (2).
- Remove the O-ring seal from the engine oil pressure sensor.
Show/hide table
| |
| Illustration 1 | g01082885 |
Show/hide table
| NOTICE |
|---|
|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Install a new O-ring seal on the engine oil pressure sensor.
- Install engine oil pressure sensor (2).
- Connect harness assembly (1).
Show/hide table
|
| |
| Illustration 2 | g01082885 |
Caterpillar Information System:
C15 On-highway Engines Variable Valve Actuator Oil Pressure Sensor - Remove and Install
C15 On-highway Engines Crankshaft Position Sensor - Remove and Install
C15 On-highway Engines Camshaft Position Sensor - Remove and Install
G3520B Industrial Engine Replacing the ECM
C13, C15, and C18 Tier 4 Final Engines Engine Oil Pan
3412E, C30 and C32 Marine Engines Fuel Transfer Pump - Install
C-10 and C-12 Truck Engines Boost Pressure Sensor
3412E, C30 and C32 Marine Engines Fuel Transfer Pump - Remove
2004/07/05 Improved Analysis of Non-Warrantable Failures for Reman Vane Cartridges {5055}
2004/07/01 Engines Are Now Built with Semi-Crowned Lifter Rollers {1209}
3412E, C30 and C32 Marine Engines Fuel Filter Base - Remove and Install
3412E, C30 and C32 Marine Engines Fuel Priming Pump - Remove and Install
C27 and C32 Engines Electronic Unit Injector - Adjust
C15 On-highway Engines Atmospheric Pressure Sensor - Remove and Install
C15 On-highway Engines Fuel Temperature Sensor - Remove and Install
C15 On-highway Engines Boost Pressure Sensor - Remove and Install
C15 On-highway Engines Coolant Temperature Sensor - Remove and Install
C11 and C13 Petroleum Engines General Information
G3520B Industrial Engine Replacing the ITSM
G3516B Engines Symptoms
G3520B Industrial Engine Electronic Service Tool Will Not Communicate with ECM - The Caterpillar Electronic Technician (ET) Will Not Communicate With an Electronic Control Module (ECM) and/or the Integrated Temperature Sensing Module (ITSM)
G3520B Industrial Engine Intermittent Engine Shutdown
2004/07/01 A New Connecting Rod Bearing is Used for High Compression Ratio Generator Set Engines {1219}
C15 and C18 Industrial Engines Exhaust Elbow