Fuel Transfer Pump - Install
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Install fuel transfer pump (2).
- Install bolts (3). Tighten the bolts to a torque of
16 ± 1 N·m (12 ± 1 lb ft) . - Install hose assembly (4).
Show/hide table
Illustration 2 g01082041 - Connect hose assemblies (1) to fuel transfer pump (2).
Show/hide table
Illustration 1 | g01082044 |
Caterpillar Information System:
C-10 and C-12 Truck Engines Boost Pressure Sensor
3412E, C30 and C32 Marine Engines Fuel Transfer Pump - Remove
2004/07/05 Improved Analysis of Non-Warrantable Failures for Reman Vane Cartridges {5055}
2004/07/01 Engines Are Now Built with Semi-Crowned Lifter Rollers {1209}
3412E, C30 and C32 Marine Engines Fuel Filter Base - Remove and Install
3412E, C30 and C32 Marine Engines Fuel Priming Pump - Remove and Install
2004/08/01 Corrosion-Resistant Sensor and Elbow Are Now Available {1917}
C15 On-highway Engines Cylinder Head - Install
C15 On-highway Engines Cylinder Head - Remove
2004/11/01 A New Abrasion Resistant Fuel Line is Now Used {1274}
3126B Petroleum Engine Electronic Service Tools
G3500 Engines Ignition System Spark Plugs - Inspect/Replace
C13, C15, and C18 Tier 4 Final Engines Engine Oil Pan
G3520B Industrial Engine Replacing the ECM
C15 On-highway Engines Camshaft Position Sensor - Remove and Install
C15 On-highway Engines Crankshaft Position Sensor - Remove and Install
C15 On-highway Engines Variable Valve Actuator Oil Pressure Sensor - Remove and Install
C15 On-highway Engines Engine Oil Pressure Sensor - Remove and Install
C27 and C32 Engines Electronic Unit Injector - Adjust
C15 On-highway Engines Atmospheric Pressure Sensor - Remove and Install
C15 On-highway Engines Fuel Temperature Sensor - Remove and Install
C15 On-highway Engines Boost Pressure Sensor - Remove and Install
C15 On-highway Engines Coolant Temperature Sensor - Remove and Install
C11 and C13 Petroleum Engines General Information