Atmospheric Pressure Sensor - Remove and Install
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Disconnect harness assembly (1).
- Remove atmospheric pressure sensor (2).
- Remove the O-ring seal from the atmospheric pressure sensor.
Show/hide table
Illustration 1 | g01082917 |
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Install a new O-ring seal on the atmospheric pressure sensor.
- Install atmospheric pressure sensor (2).
- Connect harness assembly (1).
Show/hide table
Illustration 2 | g01082917 |
Caterpillar Information System:
C27 and C32 Engines Electronic Unit Injector - Adjust
C15 On-highway Engines Engine Oil Pressure Sensor - Remove and Install
C15 On-highway Engines Variable Valve Actuator Oil Pressure Sensor - Remove and Install
C15 On-highway Engines Crankshaft Position Sensor - Remove and Install
C15 On-highway Engines Camshaft Position Sensor - Remove and Install
G3520B Industrial Engine Replacing the ECM
C13, C15, and C18 Tier 4 Final Engines Engine Oil Pan
3412E, C30 and C32 Marine Engines Fuel Transfer Pump - Install
C-10 and C-12 Truck Engines Boost Pressure Sensor
3412E, C30 and C32 Marine Engines Fuel Transfer Pump - Remove
2004/07/05 Improved Analysis of Non-Warrantable Failures for Reman Vane Cartridges {5055}
2004/07/01 Engines Are Now Built with Semi-Crowned Lifter Rollers {1209}
C15 On-highway Engines Fuel Temperature Sensor - Remove and Install
C15 On-highway Engines Boost Pressure Sensor - Remove and Install
C15 On-highway Engines Coolant Temperature Sensor - Remove and Install
C11 and C13 Petroleum Engines General Information
G3520B Industrial Engine Replacing the ITSM
G3516B Engines Symptoms
G3520B Industrial Engine Electronic Service Tool Will Not Communicate with ECM - The Caterpillar Electronic Technician (ET) Will Not Communicate With an Electronic Control Module (ECM) and/or the Integrated Temperature Sensing Module (ITSM)
G3520B Industrial Engine Intermittent Engine Shutdown
2004/07/01 A New Connecting Rod Bearing is Used for High Compression Ratio Generator Set Engines {1219}
C15 and C18 Industrial Engines Exhaust Elbow
C15 and C18 Industrial Engines Exhaust Elbow
C15 Petroleum Generator Set Engines Exhaust Elbow