953C Track-Type Loader Caterpillar

Illustration 1	g00953110

1. Raise the bucket and dump the bucket. Move the tilt control lever to TILT BACK detent position.

2. When the present bucket angle is reached, the control lever returns to HOLD position. Lower the bucket and check the cutting angle.

Show/hide table



Illustration 2	g00986425

3. Position the bucket on the ground.

Single Lever Control

Show/hide table



Illustration 3	g01000356

1. Move the single lever control to position (1) in order to raise the bucket. Move the single lever control to position (4) in order to dump the bucket. Move the single lever control to TILT BACK detent position (3) .

2. When the present bucket angle is reached, the single lever control returns to HOLD position. Move the control lever to position (2) in order to lower the bucket and check the cutting angle.

3. Position the bucket on the ground.

Adjust:

Illustration 4	g00994767

1. Loosen bolts (1) while you tighten screw (2) in order to adjust the bucket positioner. Horizontally center bucket positioner switch assembly (3) over magnet (4) .

2. Tighten bolts (1) in order to secure this position.

3. Callout (A) is the dimension from the switch to the magnet. The correct measurement is 5 mm (0.20 inch) to 7 mm (0.28 inch).