Backup Alarm
The backup alarm is located at the rear of the machine.
The alarm sounds when the transmission control lever is in the REVERSE position. The backup alarm is used to alert people behind the machine.
Show/hide table
Illustration 1 | g00100669 |
A three-position switch is located on the backup alarm. The switch has HIGH, LOW, and MEDIUM positions. The three-position switch regulates the volume of the alarm.
The alarm is set from the factory at the highest sound level. The setting should remain in the HIGH position, unless the job site requires a lower sound level.
Caterpillar Information System:
621F Wheel Tractor-Scraper Horn
953C Track-Type Loader Engine Start Switch
953C Track-Type Loader Air Inlet Heater Starting Aid
953C Track-Type Loader Backup Alarm
953C Track-Type Loader Steering Control
994 Wheel Loader Hydraulic System Linkage Pin and Seal Group (Bucket Control)
953C Track-Type Loader Speed Override and Brake Control
953C Track-Type Loader Ripper Control
613C Series II Wheel Tractor 3116 Engine Supplement Radiator - Remove
966G and 972G Wheel Loaders Transmission Neutralizer Override Control
953C Track-Type Loader Multipurpose Bucket Control
953C Track-Type Loader Seat Adjustment
627F Wheel Tractor-Scraper Heating and Air Conditioning Control
953C Track-Type Loader Heating and Air Conditioning Controls - If Equipped
953C Track-Type Loader Window Wiper and Washer Control
611 Wheel Tractor-Scraper 3306B Engine Supplement Radiator - Remove
992G Wheel Loader Electrohydraulic System Pilot Control Actuator Current (Proportional Solenoid) - Check
966G and 972G Wheel Loaders Transmission Control - Command Control Steering
953C Track-Type Loader Light Switches
994 Wheel Loader Steering System Steering Metering Pump
953C Track-Type Loader Monitoring System
953C Track-Type Loader Bucket Positioner
953C Track-Type Loader Tracks
966G and 972G Wheel Loaders Transmission Control - Conventional Steering