Engine Oil Pressure Sensor - Remove and Install
Show/hide table
注意 |
---|
在检验、保养、测试、调整及维修发动机时,请小心确保盛接流出的液体。 在打开或拆解任何储有液体的部件之前,要准备好合适的容器收集液体。 有关适合收集和盛接卡特彼勒产品上的液体的工具和供应品,请参阅专门出版物, NENG2500, "卡特彼勒代理商工具目录"。 按照本地法规和条例处置所有液体。 |
Show/hide table
注意 |
---|
保持所有零件清洁无杂质。 杂质会造成快速磨损和缩短部件寿命。 |
- 断开线束组件 (1)。
- 将发动机机油压力传感器 (2) 从缸体上的适配器上拆下。
- 将 O 形密封圈从发动机机油压力传感器上拆下。
Show/hide table
图 1 | g01095806 |
Show/hide table
注意 |
---|
保持所有零件清洁无杂质。 杂质会造成快速磨损和缩短部件寿命。 |
- 将一个新的 O 形密封圈安装在发动机机油压力传感器上。
- 安装发动机机油压力传感器 (2) 并拧紧至扭矩为
10 ± 2 N·m (89 ± 18 lb in) 。 - 连接线束组件 (1)。
Show/hide table
图 2 | g01095806 |
Caterpillar Information System:
C15 and C18 Generator Set Engines Atmospheric Pressure Sensor - Remove and Install
3406E and 3456 Generator Set Engines Emergency Stop Switch Circuit - Test
C15 Petroleum Engines Pump Drive - Install
C15 Petroleum Engines Pump Drive - Remove
Machining of The Cylinder Block to Convert from Wet Cylinder Liners to Dry Cylinders Liners{1201} Machining of The Cylinder Block to Convert from Wet Cylinder Liners to Dry Cylinders Liners{1201}
3508, 3512, and 3516 Generator Sets Refill Capacities and Recommendations
3406E and 3456 Generator Set Engines Air Shutoff System - Test
Product Link - PL102C Reports and Messages Not Available
C15 Engine Reference Material
C11 and C13 Petroleum Engines Plate Locations and Film Locations
12M Motor Grader Blade Lift Cylinder Socket - Check/Adjust/Replace
12M Motor Grader Blade Lift Cylinder Socket - Lubricate
3406E and 3456 Generator Set Engines ATA (SAE J1587 / J1708) Data Link Circuit - Test
C15 and C18 Industrial Engines Coolant Temperature Sensor - Remove and Install
3406E and 3456 Generator Set Engines Overspeed Verify Switch Circuit - Test
2004/04/01 The Power Steering Pump May not be Seated Properly {1151, 4306}
C15 and C18 Generator Set Engines Turbocharger Outlet Pressure Sensor - Remove and Install
C15 and C18 Industrial Engines Crankshaft Position Sensor - Remove and Install
Operating Controls For The Multiline-2 Controller{7451} Operating Controls For The Multiline-2 Controller{7451}
C15 and C18 Industrial Engines Camshaft Position Sensor - Remove and Install
3406E and 3456 Generator Set Engines Engine Sensor Open/Short Circuit - Test
C-15 Petroleum Engine Fuel Temperature Sensor - Remove and Install
3406E and 3456 Generator Set Engines CID 0535 FMI 08 Exhaust Temperature Sensor noisy signal
C-15 Petroleum Engine Fuel Pressure Sensor - Remove and Install