Camshaft Position Sensor - Remove and Install
Show/hide table
| 注意 |
|---|
|
在检验、保养、测试、调整及维修发动机时，请小心确保盛接流出的液体。 在打开或拆解任何储有液体的部件之前，要准备好合适的容器收集液体。 有关适合收集和盛接卡特彼勒产品上的液体的工具和供应品，请参阅专门出版物, NENG2500, "卡特彼勒代理商工具目录"。 按照本地法规和条例处置所有液体。 |
Show/hide table
| 注意 |
|---|
|
保持所有零件清洁无杂质。 杂质会造成快速磨损和缩短部件寿命。 |
- 断开线束组件 (1)。
- 拆下螺栓 (3) 和凸轮轴位置传感器 (2)。
- 将 O 形密封圈从凸轮轴位置传感器上拆下。
Show/hide table
| |
| 图 1 | g01068233 |
Show/hide table
| 注意 |
|---|
|
保持所有零件清洁无杂质。 杂质会造成快速磨损和缩短部件寿命。 |
- 在凸轮轴位置传感器上安装一个新的 O 形密封圈。 用清洁的发动机机油润滑 O 形密封圈。
- 将凸轮轴位置传感器 (2) 安置到壳体中并安装螺栓 (3)。
- 连接线束组件 (1)。
Show/hide table
|
| |
| 图 2 | g01068233 |
Caterpillar Information System:
Operating Controls For The Multiline-2 Controller{7451} Operating Controls For The Multiline-2 Controller{7451}
C15 and C18 Industrial Engines Crankshaft Position Sensor - Remove and Install
C15 and C18 Generator Set Engines Turbocharger Outlet Pressure Sensor - Remove and Install
2004/04/01 The Power Steering Pump May not be Seated Properly {1151, 4306}
3406E and 3456 Generator Set Engines Overspeed Verify Switch Circuit - Test
C15 and C18 Industrial Engines Coolant Temperature Sensor - Remove and Install
3406E and 3456 Generator Set Engines ATA (SAE J1587 / J1708) Data Link Circuit - Test
C15 and C18 Generator Set Engines Engine Oil Pressure Sensor - Remove and Install
C15 and C18 Generator Set Engines Atmospheric Pressure Sensor - Remove and Install
3406E and 3456 Generator Set Engines Emergency Stop Switch Circuit - Test
C15 Petroleum Engines Pump Drive - Install
C15 Petroleum Engines Pump Drive - Remove
3406E and 3456 Generator Set Engines Engine Sensor Open/Short Circuit - Test
C-15 Petroleum Engine Fuel Temperature Sensor - Remove and Install
3406E and 3456 Generator Set Engines CID 0535 FMI 08 Exhaust Temperature Sensor noisy signal
C-15 Petroleum Engine Fuel Pressure Sensor - Remove and Install
C15 and C18 Generator Set Engines Inlet Air Temperature Sensor - Remove and Install
C27 and C32 Generator Set Engines CID 0446 FMI 05 Air Shutoff Relay open
C27 and C32 Generator Set Engines CID 0446 FMI 06 Air Shutoff Relay short
3406E and 3456 Generator Set Engines CID 0460 FMI 02 Filtered Fuel Pressure misinstalled
3406E and 3456 Generator Set Engines CID 0460 FMI 03 Filtered Fuel Pressure open/short to +batt
Product Link - PL102C Electronic Control Module (ECM) - Replace
3406E and 3456 Generator Set Engines CID 0460 FMI 04 Filtered Fuel Pressure short to ground
3406E and 3456 Generator Set Engines CID 0460 FMI 13 Filtered Fuel Pressure calibration required