The Power Steering Pump May not be Seated Properly {1151, 4306}
- Engine:
- C11 (S/N: KCA161-605)
- C13 (S/N: KCB508-2100)
Description of Change: Some C11 and C13 On-highway Engines have experienced oil leaks between the power steering pump and the front adapter cover. The power steering pump may not seat properly due to a ledge in the front adapter cover. Dealers should replace the front adapter cover for the power steering pump if a leak is present. Use the 251-4314 Adapter (Cover) for the repair. All of the suspect parts have been purged from the parts system.
Adaptable To: This change is adaptable to S/N:KCA161-606 and with the S/N:; KCB508-2100. The change is effective with the S/N:; KCA606-UP and with the S/N:; KCB2101-UP.
Caterpillar Information System:
3406E and 3456 Generator Set Engines Overspeed Verify Switch Circuit - Test
C15 and C18 Industrial Engines Coolant Temperature Sensor - Remove and Install
3406E and 3456 Generator Set Engines ATA (SAE J1587 / J1708) Data Link Circuit - Test
C15 and C18 Generator Set Engines Engine Oil Pressure Sensor - Remove and Install
C15 and C18 Generator Set Engines Atmospheric Pressure Sensor - Remove and Install
3406E and 3456 Generator Set Engines Emergency Stop Switch Circuit - Test
C15 Petroleum Engines Pump Drive - Install
C15 Petroleum Engines Pump Drive - Remove
Machining of The Cylinder Block to Convert from Wet Cylinder Liners to Dry Cylinders Liners{1201} Machining of The Cylinder Block to Convert from Wet Cylinder Liners to Dry Cylinders Liners{1201}
3508, 3512, and 3516 Generator Sets Refill Capacities and Recommendations
3406E and 3456 Generator Set Engines Air Shutoff System - Test
Product Link - PL102C Reports and Messages Not Available
C15 and C18 Generator Set Engines Turbocharger Outlet Pressure Sensor - Remove and Install
C15 and C18 Industrial Engines Crankshaft Position Sensor - Remove and Install
Operating Controls For The Multiline-2 Controller{7451} Operating Controls For The Multiline-2 Controller{7451}
C15 and C18 Industrial Engines Camshaft Position Sensor - Remove and Install
3406E and 3456 Generator Set Engines Engine Sensor Open/Short Circuit - Test
C-15 Petroleum Engine Fuel Temperature Sensor - Remove and Install
3406E and 3456 Generator Set Engines CID 0535 FMI 08 Exhaust Temperature Sensor noisy signal
C-15 Petroleum Engine Fuel Pressure Sensor - Remove and Install
C15 and C18 Generator Set Engines Inlet Air Temperature Sensor - Remove and Install
C27 and C32 Generator Set Engines CID 0446 FMI 05 Air Shutoff Relay open
C27 and C32 Generator Set Engines CID 0446 FMI 06 Air Shutoff Relay short
3406E and 3456 Generator Set Engines CID 0460 FMI 02 Filtered Fuel Pressure misinstalled