Water Pump - Install
Show/hide table
Required Tools | |||
---|---|---|---|
Tool | Part Number | Part Description | Qty |
A | 1U-6396 | O-Ring Assembly Compound | - |
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Position water pump (4) in the front housing. Install bolts (5).
- Apply Tooling (A) to the O-ring seal on adapter (12).
- Position water pump cover (6) on adapter (12). Install bolts (10).
- Install the O-ring seal on oil cooler bonnet (11). Apply Tooling (A) to the O-ring seal on the oil cooler bonnet.
- Position oil cooler bonnet (11) and integral seal (8) on water pump (4). Install bolts (9).
- Connect hose assembly (7) to the oil cooler bonnet.
- Install the O-ring seal on bypass elbow (3). Apply Tooling (A) to the O-ring seal on the bypass elbow.
- Position bypass elbow (3) and gasket (2) on the cover assembly. Install bolts (1).
- Fill the cooling system. Refer to Operation and Maintenance Manual, "Cooling System Coolant - Change".
Show/hide table
Illustration 1 | g01063923 |
Caterpillar Information System:
C-15 Petroleum Engine Troubleshooting
C15 Petroleum Engines Water Pump - Remove
3126B Engine for Caterpillar Built Machines CID 0006 FMI 11 Cylinder #6 Injector fault
C15 and C18 Industrial Engines Fuel Filter Base - Assemble
3126B Engine for Caterpillar Built Machines CID 0005 FMI 11 Cylinder #5 Injector fault
C15 and C18 Industrial Engines Fuel Filter Base - Disassemble
3126B Engine for Caterpillar Built Machines CID 0004 FMI 11 Cylinder #4 Injector fault
3126B Engine for Caterpillar Built Machines CID 0003 FMI 11 Cylinder #3 Injector fault
3126B Engine for Caterpillar Built Machines CID 0002 FMI 11 Cylinder #2 Injector fault
3126B Engine for Caterpillar Built Machines CID 0001 FMI 11 Cylinder #1 Injector fault
G3520C and G3520E Generator Set Engines Exhaust Elbow - Remove and Install
3126B Petroleum Engine Installation Environment
3406E, C-10 and C-12 On-highway Engines ATA (SAE J1587 / J1708) Data Link Circuit - Test
C15 and C18 Industrial Engines Belt Tightener - Remove
C15 and C18 Industrial Engines Belt Tightener - Install
C15 and C18 Industrial Engines Belt Tightener - Disassemble
C15 and C18 Industrial Engines Belt Tightener - Assemble
C-15 Petroleum Engine Fuel System - Prime
2004/06/07 Replace the Fuel Injector Hold-Down Bolt When You Service Electronic Unit Injectors {1251, 1290}
2004/05/01 Use The Correct Stub Shaft For The Crankshaft {1237, 1359}
C9 Urban Transit Bus Engine Air Inlet and Exhaust System
2004/06/01 Replace the Fuel Injector Hold-Down Bolt When You Service Electronic Unit Injectors {1290}
C-15 Petroleum Engine Fuel System Pressure - Test
2004/04/01 Serviceable Parts are Now Available for Water Pumps {1361}