Belt Tightener - Assemble
Show/hide table
所需工具 | |||
工具 | 零件号 | 零件说明 | 数量 |
A | 1P-0510 | 冲头总成 | 1 |
B | 1P-0808 | 多功能润滑脂 | - |
Show/hide table
注意 |
---|
保持所有零件清洁无杂质。 杂质会造成快速磨损和缩短部件寿命。 |
- 将隔套 (11) 装到支架 (1) 上。
Show/hide table
图 2 g01064232 - 使用工具 (A) 将轴承 (14) 安装在皮带轮 (2) 中。
- 安装隔套 (13)。
- 使用工具 (A) 安装轴承 (12)。
- 使用工具 (A) 安装唇型密封 (8)。 使用工具 (B) 润滑唇形密封。
- 安装黄油嘴 (9)。
- 将 O 形密封圈 (10) 安装到皮带轮中。
Show/hide table
图 3 g01064042 - 将皮带轮 (2) 安装到支架 (1) 上。
- 安装垫圈 (4) 和螺栓 (5)。
- 定位盖 (3),然后安装螺栓 (7)。 将压力释放接头 (6) 安装到盖中。
- 使用工具 (B) 润滑轴承。
Show/hide table
图 1 | g01064234 |
结束:
- 安装皮带张紧器。 请参阅拆解和组装, "皮带张紧器 - 安装"。
Caterpillar Information System:
C15 and C18 Industrial Engines Belt Tightener - Disassemble
C15 and C18 Industrial Engines Belt Tightener - Install
C15 and C18 Industrial Engines Belt Tightener - Remove
3406E, C-10 and C-12 On-highway Engines ATA (SAE J1587 / J1708) Data Link Circuit - Test
C15 Petroleum Engines Water Pump - Install
C-15 Petroleum Engine Troubleshooting
C15 Petroleum Engines Water Pump - Remove
3126B Engine for Caterpillar Built Machines CID 0006 FMI 11 Cylinder #6 Injector fault
C15 and C18 Industrial Engines Fuel Filter Base - Assemble
3126B Engine for Caterpillar Built Machines CID 0005 FMI 11 Cylinder #5 Injector fault
C15 and C18 Industrial Engines Fuel Filter Base - Disassemble
3126B Engine for Caterpillar Built Machines CID 0004 FMI 11 Cylinder #4 Injector fault
C-15 Petroleum Engine Fuel System - Prime
2004/06/07 Replace the Fuel Injector Hold-Down Bolt When You Service Electronic Unit Injectors {1251, 1290}
2004/05/01 Use The Correct Stub Shaft For The Crankshaft {1237, 1359}
C9 Urban Transit Bus Engine Air Inlet and Exhaust System
2004/06/01 Replace the Fuel Injector Hold-Down Bolt When You Service Electronic Unit Injectors {1290}
C-15 Petroleum Engine Fuel System Pressure - Test
2004/04/01 Serviceable Parts are Now Available for Water Pumps {1361}
3406E and 3456 Generator Set Engines Excessive White Smoke
3406E and 3456 Generator Set Engines Intermittent Low Power or Power Cutout
2004/07/01 Improved Turbocharger Water Lines are Used {1052, 1059, 1380}
C15 and C18 Industrial Engines Fan Drive - Remove
C15 and C18 Industrial Engines Fan Drive - Install