Belt Tightener - Disassemble
拆解步骤
开始:
- 拆下皮带张紧器。 请参考拆解和组装, "皮带张紧器 - 拆卸"。
Show/hide table
注意 |
---|
保持所有零件清洁无杂质。 杂质会造成快速磨损和缩短部件寿命。 |
- 拆下螺栓 (7) 。 拆下盖 (3) 。 从盖上拆下压力释放接头 (6) 。
Show/hide table
图 1 | g01064042 |
- 拆下螺栓 (5) 和垫圈 (4) 。
- 将支架 (1) 从皮带轮 (2) 上拆下。
- 将 O 形密封圈 (10) 从皮带轮 (2) 上拆下。 拆下黄油嘴 (9) 。
Show/hide table
图 2 | g01064118 |
- 将隔板 (11) 从皮带轮 (2) 上拆下。 拆下唇型密封 (8) 。
- 拆下轴承 (12) 和轴承 (14) 。 拆下隔套 (13) 。
Caterpillar Information System:
C15 and C18 Industrial Engines Belt Tightener - Install
C15 and C18 Industrial Engines Belt Tightener - Remove
3406E, C-10 and C-12 On-highway Engines ATA (SAE J1587 / J1708) Data Link Circuit - Test
C15 Petroleum Engines Water Pump - Install
C-15 Petroleum Engine Troubleshooting
C15 Petroleum Engines Water Pump - Remove
3126B Engine for Caterpillar Built Machines CID 0006 FMI 11 Cylinder #6 Injector fault
C15 and C18 Industrial Engines Fuel Filter Base - Assemble
3126B Engine for Caterpillar Built Machines CID 0005 FMI 11 Cylinder #5 Injector fault
C15 and C18 Industrial Engines Fuel Filter Base - Disassemble
3126B Engine for Caterpillar Built Machines CID 0004 FMI 11 Cylinder #4 Injector fault
3126B Engine for Caterpillar Built Machines CID 0003 FMI 11 Cylinder #3 Injector fault
C15 and C18 Industrial Engines Belt Tightener - Assemble
C-15 Petroleum Engine Fuel System - Prime
2004/06/07 Replace the Fuel Injector Hold-Down Bolt When You Service Electronic Unit Injectors {1251, 1290}
2004/05/01 Use The Correct Stub Shaft For The Crankshaft {1237, 1359}
C9 Urban Transit Bus Engine Air Inlet and Exhaust System
2004/06/01 Replace the Fuel Injector Hold-Down Bolt When You Service Electronic Unit Injectors {1290}
C-15 Petroleum Engine Fuel System Pressure - Test
2004/04/01 Serviceable Parts are Now Available for Water Pumps {1361}
3406E and 3456 Generator Set Engines Excessive White Smoke
3406E and 3456 Generator Set Engines Intermittent Low Power or Power Cutout
2004/07/01 Improved Turbocharger Water Lines are Used {1052, 1059, 1380}
C15 and C18 Industrial Engines Fan Drive - Remove