Fuel System Primary Filter (Water Separator) Element - Replace
燃油中有水可能导致发动机运转粗暴。 燃油中有水可以导致燃油系统部件失效。 如果燃油被水污染,滤芯应在正常换油周期之前更换。
Show/hide table
渗漏或溅溢到热表面或电气部件上的燃油会引起失火。 为防止可能的伤害,当更换燃油滤清器或油水分离器滤芯时,要将起动开关断开。 应立即将溅溢的燃油清除干净。 |
Show/hide table
图 1 | g00907911 |
(1) 排气塞
(2) 底座 (3) 壳体 (4) 滤芯 (5) 排放塞 |
- 关闭主供油阀。
- 卸下排放塞 (5)。 按下排气塞 (1),使燃油开始流动。 使燃油排放到适当的容器中。 妥善处理燃油。
- 安装排放螺塞。
- 从底座 (2)上卸下壳体 ( 3)。
- 从壳体上卸下滤芯 ( 4)。 处置用过的滤芯。
- 取下密封垫。 清洁以下部件:
- 壳体
- 密封垫
- 底座
检查密封垫是否损坏和老化。 必要时,更换密封垫。
- 安装密封垫。 用干净的柴油润滑密封垫。
Show/hide table
注意 粗滤器/油水分离器可以被预先注满,以避免发动机因燃油中有空气而造成运转粗暴/停转。 安装前不要用燃油注满细滤器。 这些燃油将不被过滤并可能受到污染。 污染的燃油会加速燃油系统零件的磨损。
- 将新滤芯装入壳体内。 此时可以向壳体充油。
- 将壳体安装在底座上。 用手拧紧壳体。 不要使用工具来拧紧壳体。
Show/hide table
注意 发动机正常运行时,油水分离器处于负压状态。 确保放气塞拧紧牢固,以防止空气进入燃油系统。
- 打开主供油阀。
- 起动发动机,检查渗漏。 运转发动机1分钟。 使发动机停机,再次检查渗漏。
Caterpillar Information System:
2004/05/01 New Special Instruction, REHS1846, "Installation of the 246-3256 Parts Kit (TACHOMETER)" Is Available {7462}
3406E, C-10 and C-12 On-highway Engines Intermittent Cruise Control, Idle, or PTO Kickout
2004/03/22 An Improved Corporate Padlock Is Available {7430}
3406E, C-10 and C-12 On-highway Engines Excessive Black Smoke
2004/05/10 The Procedure for the Removal of the Electronic Unit Injector has Changed. {1290}
2004/05/10 The Procedure for the Installation of the Electronic Unit Injector has changed. {1290}
2004/05/01 A Wiring Harness Kit is Now Available {1290, 1408}
3126B Petroleum Engine Plate Locations and Film Locations
3126B Petroleum Engine Engine Description
3126B Petroleum Engine Safety Messages
Electric Power Generation Principles Voltage Control
C-15 Petroleum Engine Exhaust Manifold - Remove and Install
3406E, C-10 and C-12 On-highway Engines Intermittent Engine Shutdown
C18 Industrial Engines Safety Messages
C-15 Petroleum Engine Engine Oil Pan
3406E, C-10 and C-12 On-highway Engines Intermittent Low Power or Power Cutout
C15 and C18 Industrial Engines Belt Tightener
3406E, C-10 and C-12 On-highway Engines Low Power/Poor or No Response to Throttle
Product Link - PL102C System Overview
3406E, C-10 and C-12 On-highway Engines Poor Acceleration or Response
3406E, C-10, C-12, C-15, C-16 Truck Engines Product Storage
2004/04/01 Relocation of the Fuel Transfer Pump is Recommended for Certain Applications. {1256}
2006/01/02 Relocation of the Fuel Transfer Pump is Recommended for Certain Applications. {1256}
C15 and C18 Generator Set Engines Electronic Unit Injector - Remove