Usage:
start by:
a) remove radiator and guard
1. Loosen the tension on the fan and alternator belts (1). Remove the fan and alternator belts.
2. Loosen the bolt (2) in the end of the crankshaft until there is approximately .375 in. (9.5 mm) clearance between the washer and crankshaft pulley.
3. Install tooling (A) and loosen the pulley from the crankshaft. Remove tooling (A).
4. Remove the bolt, washer, and crankshaft pulley from the crankshaft.
Install Crankshaft Pulley
1. Put crankshaft pulley (1) in position on the crankshaft.
2. Install the washer and bolt that holds the pulley in place.
3. Install 1/2"-13 NC bolts (2) 11/2" long in the pulley as shown. Put a pry bar between the bolts to keep the crankshaft in position when the bolt is tightened to the correct torque.
5. Hit the bolt with a hammer. Tighten the bolt again to a torque of 230 ± 20 lb.ft. (307 ± 25 N·m).
4. Tighten the bolt to a torque of 230 ± 20 lb.ft. (307 ± 25 N·m).
6. Put the fan and alternator belts in position on the pulleys. Make an adjustment to the belt tension. See INSTALL FAN AND ALTERNATOR BELTS.
end by:
a) install radiator and guard