Water Pump - Disassemble
拆解步骤
Show/hide table
所需工具     | |||
---|---|---|---|
工具     | 零件号     | 零件描述     | 数量     |
A     | 8S-2264     | 拉拔器总成     | 1     |
4B-3903 | 螺栓     | 2     | |
1P-0456 | 板     | 1     | |
4B-4277 | 垫圈     | 2     | |
B     | 9S-9152     | 轴承拉拔器总成     | 1     |
C     | 1P-0510     | 冲头总成     | 1     |
开始:
- 拆下水泵。 请参阅拆解和组装, "水泵 - 拆卸"。
Show/hide table
注意 |
---|
保持所有零件清洁无杂质。 杂质会造成快速磨损和缩短部件寿命。 |
- 从水泵壳体 (3) 上卸下 O 形密封圈 (4) 。
Show/hide table
图 1 | g01045505 |
- 从进气接头 (1) 上卸下 O 形密封圈 (6) 。
- 从水泵壳体 (3) 上卸下进气接头 (1) 。 拆下 O 形密封圈 (2) 。
- 从水泵壳体 (3) 上卸下水泵滤清器 (17) 。
- 从水泵轴 (13) 上卸下螺栓 (11) 和垫圈 (9) 。
- 使用工具 (A) 将叶轮 (7) 从水泵轴 (13) 上拆下。
- 从水泵轴 (13) 上卸下螺栓 (12) 和垫圈 (10) 。
- 从水泵轴 (13) 上卸下齿轮 (5) 。
- 从水泵壳体上拆下螺栓 (18) 和护圈 (8) 。
- 从水泵壳体上卸下水泵轴 (13) 。
- 使用适当的压具和工具 (B) ,将轴承组件 (15) 从水泵轴 (13) 上拆下。
- 使用适当的压具和工具 (C) ,从水泵壳体 (3) 上卸下密封总成 (14) 。
- 使用适当的压具和工具 (C) ,从水泵壳体 (3) 上卸下唇形密封 (16) 。
Caterpillar Information System:
C15 and C18 Engines for Caterpillar Built Machines Water Pump - Install
C15 and C18 Engines for Caterpillar Built Machines Water Pump - Remove
C27 and C32 Generator Set Engines CID 0091 FMI 08 Throttle Position signal abnormal
Install the Correct Piston Cooling Jet and the Correct Retainer for the One-Piece Piston{1214, 1331} Install the Correct Piston Cooling Jet and the Correct Retainer for the One-Piece Piston{1214, 1331}
C9 Marine Auxiliary and Marine Generator Set Engines Low Power/Poor or No Response to Throttle
C15 and C18 Engines for Caterpillar Built Machines Water Temperature Regulator Housing - Remove and Install
C7 Engine for 584 and 584HD Forwarders and for 525C, 535C, and 545C Wheel Skidders Intermittent Engine Shutdown
2004/01/01 A Special Instruction, REHS2060 , "Installation Instructions for the 240-0717 Engine Oil Lines Gp for the Hydraulic Electronic Unit Injector (HEUI) Pump" is Available {1307, 1714}
2006/06/26 Some Pistons and Cylinder Packs are Cancelled and Replaced {1214}
2004/05/03 New Hydraulic Hose Assembly Machine Integrates Crimputer II with Radial Crimping Technology {0738}
C18 Marine Auxiliary Engines Engine Pressure Sensor Open or Short Circuit - Test
G3500 Engines Diagnostic Reset Switch
C15 and C18 Engines for Caterpillar Built Machines Water Pump - Assemble
3126B Industrial Engine Electronic Control Module - Remove and Install
C18 Marine Auxiliary Engines Event Codes
C18 Marine Auxiliary Engines Diagnostic Codes
G3500 Engines Control Module Self Test
2004/01/01 A New Spring for the Oil Filter Bypass Valve and for the Oil Cooler Bypass Valve is Now in Production {1306, 1314, 1318, 1378}
2004/03/01 A New Spring for the Oil Filter Bypass Valve and for the Oil Cooler Bypass Valve is Now in Production {1306, 1314, 1318, 1378}
C18 Marine Generator Set Engines CID 1929 FMI 03 Fuel Return Temperature Sensor voltage high/short to +batt
C18 Marine Generator Set Engines CID 1929 FMI 04 Fuel Return Temperature Sensor voltage low/short to ground
C13, C15, and C18 Generator Set Engines E368 High Intake Manifold Air Temperature
C18 Marine Auxiliary Engines Sensors and Electrical Connectors
C13, C15, and C18 Generator Set Engines E009 High Altitude Derate