2004/01/01 Caterpillar


A New Spring for the Oil Filter Bypass Valve and for the Oil Cooler Bypass Valve is Now in Production {1306, 1314, 1318, 1378}

Usage:

3126 1ZJ
Engine:
3116 (S/N: 2MR1-UP)
3126 (S/N: 1ZJ1-UP; CKK1-UP; 6MK1-UP)
3126B (S/N: 9ZF1-UP; DCS1-UP; BEJ1-UP)
C-9 (S/N: CSN1-UP; CLJ1-UP)

A new stronger spring for the engine oil filter bypass valve and the engine oil cooler bypass valve has been released. The new spring has a higher spring rate and a higher preload when the spring is assembled. This combination of spring rate and preload improves cleanliness of the oil by allowing less oil to bypass the oil filter during cold starting conditions. Specifications for the spring have also changed. Refer to Table 1.

Table 1
Comparison of Springs    
Dimensions     New Spring     Old Spring    
Outside diameter     11.0 mm (0.43 inch)    
11.2 mm (0.44 inch)    
Free length    
58.5 ± 0.50 mm (2.30 ± 0.020 inch)    

57.9 mm (2.28 inch)    
Assembled length    
43.18 mm (1.70 inch)    

43.18 mm (1.70 inch)    
Load at assembled length    
43.7 N·m (32.23 lb ft)    

4.7454 N·m (3.5 lb ft)    
Direction of coils     Left hand     Right hand    
Number of coils     17 total coils
15 active coils    
21 total coils
19 active coils    

The former 9L-9188 Spring has been replaced with the new 242-3864 Spring. Refer to Table 2 for the serial number breaks.

Table 2
Engine Model     Engine Serial Number    
3116     S/N:2MR03588
   
3126     S/N:1ZJ04021
   
3126     S/N:CKK00252
   
3126     S/N:6MK01853
   
3126B     S/N:9ZF00782
   
3126B     S/N:DCS00647
   
3126B     S/N:BEJ04634
   
C-9     S/N:CLJ004643
   
C-9     S/N:CSN00452
   

The engine has two of the 242-3864 Springs. One spring is for the oil filter bypass valve and the other spring is for the oil cooler bypass valve.

Note: Engines that are equipped with a remote oil filter base require three 242-3864 Springs .

The former 9L-9188 Spring has not been cancelled. The 9L-9188 Spring is still available for parts service in other applications of this spring.




Illustration 1g01044967

(1) 242-3864 Springs

Caterpillar Information System:

G3500 Engines Control Module Self Test
C18 Marine Auxiliary Engines Diagnostic Codes
C18 Marine Auxiliary Engines Event Codes
3126B Industrial Engine Electronic Control Module - Remove and Install
C15 and C18 Engines for Caterpillar Built Machines Water Pump - Assemble
C15 and C18 Engines for Caterpillar Built Machines Water Pump - Disassemble
C15 and C18 Engines for Caterpillar Built Machines Water Pump - Install
C15 and C18 Engines for Caterpillar Built Machines Water Pump - Remove
C27 and C32 Generator Set Engines CID 0091 FMI 08 Throttle Position signal abnormal
Install the Correct Piston Cooling Jet and the Correct Retainer for the One-Piece Piston{1214, 1331} Install the Correct Piston Cooling Jet and the Correct Retainer for the One-Piece Piston{1214, 1331}
C9 Marine Auxiliary and Marine Generator Set Engines Low Power/Poor or No Response to Throttle
C15 and C18 Engines for Caterpillar Built Machines Water Temperature Regulator Housing - Remove and Install
2004/03/01 A New Spring for the Oil Filter Bypass Valve and for the Oil Cooler Bypass Valve is Now in Production {1306, 1314, 1318, 1378}
C18 Marine Generator Set Engines CID 1929 FMI 03 Fuel Return Temperature Sensor voltage high/short to +batt
C18 Marine Generator Set Engines CID 1929 FMI 04 Fuel Return Temperature Sensor voltage low/short to ground
C13, C15, and C18 Generator Set Engines E368 High Intake Manifold Air Temperature
C18 Marine Auxiliary Engines Sensors and Electrical Connectors
C13, C15, and C18 Generator Set Engines E009 High Altitude Derate
Troubleshooting Tips Will Help Maintain Steady Engine RPM{1264, 1280} Troubleshooting Tips Will Help Maintain Steady Engine RPM{1264, 1280}
G3500 Engines Replacing the EIS Control Module
G3500 Engines Engine Speed/Timing Sensor - Calibrate
G3500 Engines Electrical Power Supply
C13, C15, and C18 Generator Set Engines Can Not Reach Top Engine RPM
2003/12/01 New Design of the Injector Provides Improved Durability {1290, 1714}
Back to top
The names Caterpillar, John Deere, JD, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
CH-Part.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only.