C15 and C18 Engines for Caterpillar Built Machines Caterpillar


Water Pump - Install

Usage:

631E 1AB

安装步骤


注意

保持所有零件清洁无杂质。

杂质会造成快速磨损和缩短部件寿命。




    图 1g01115436

  1. 将水泵 (8) 安置在前齿轮室中。

  2. 安装螺栓 (5)。

  3. 作为一个组件安装齿轮室盖 (1) 和水泵盖 (6)。

  4. 安装螺栓 (3) 和螺栓 (4)。

  5. 连接管组件 (2)。

  6. 安装管帽 (7)。

  7. 加注冷却系统。 请参阅操作和保养手册, "冷却系统冷却液 - 更换"。

Caterpillar Information System:

C15 and C18 Engines for Caterpillar Built Machines Water Pump - Remove
C27 and C32 Generator Set Engines CID 0091 FMI 08 Throttle Position signal abnormal
Install the Correct Piston Cooling Jet and the Correct Retainer for the One-Piece Piston{1214, 1331} Install the Correct Piston Cooling Jet and the Correct Retainer for the One-Piece Piston{1214, 1331}
C9 Marine Auxiliary and Marine Generator Set Engines Low Power/Poor or No Response to Throttle
C15 and C18 Engines for Caterpillar Built Machines Water Temperature Regulator Housing - Remove and Install
C7 Engine for 584 and 584HD Forwarders and for 525C, 535C, and 545C Wheel Skidders Intermittent Engine Shutdown
2004/01/01 A Special Instruction, REHS2060 , "Installation Instructions for the 240-0717 Engine Oil Lines Gp for the Hydraulic Electronic Unit Injector (HEUI) Pump" is Available {1307, 1714}
2006/06/26 Some Pistons and Cylinder Packs are Cancelled and Replaced {1214}
2004/05/03 New Hydraulic Hose Assembly Machine Integrates Crimputer II with Radial Crimping Technology {0738}
C18 Marine Auxiliary Engines Engine Pressure Sensor Open or Short Circuit - Test
G3500 Engines Diagnostic Reset Switch
2004/01/26 A New Spring for the Oil Filter Bypass Valve and for the Oil Cooler Bypass Valve is Now in Production {1306, 1314, 1318, 1378}
C15 and C18 Engines for Caterpillar Built Machines Water Pump - Disassemble
C15 and C18 Engines for Caterpillar Built Machines Water Pump - Assemble
3126B Industrial Engine Electronic Control Module - Remove and Install
C18 Marine Auxiliary Engines Event Codes
C18 Marine Auxiliary Engines Diagnostic Codes
G3500 Engines Control Module Self Test
2004/01/01 A New Spring for the Oil Filter Bypass Valve and for the Oil Cooler Bypass Valve is Now in Production {1306, 1314, 1318, 1378}
2004/03/01 A New Spring for the Oil Filter Bypass Valve and for the Oil Cooler Bypass Valve is Now in Production {1306, 1314, 1318, 1378}
C18 Marine Generator Set Engines CID 1929 FMI 03 Fuel Return Temperature Sensor voltage high/short to +batt
C18 Marine Generator Set Engines CID 1929 FMI 04 Fuel Return Temperature Sensor voltage low/short to ground
C13, C15, and C18 Generator Set Engines E368 High Intake Manifold Air Temperature
C18 Marine Auxiliary Engines Sensors and Electrical Connectors
Back to top
The names Caterpillar, John Deere, JD, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
CH-Part.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only.