Camshaft Gear - Remove and Install
Removal Procedure
Start By:
- Remove the camshaft. Refer to Disassembly and Assembly, "Camshaft - Remove".
- Wrap the camshaft with a protective covering in order to prevent damage to the camshaft.
- Place the camshaft and camshaft gear (1) in a suitable press. Press the camshaft from the camshaft gear.
Show/hide table
Illustration 1 | g01141726 |
Show/hide table
NOTICE |
---|
Do not allow the camshaft to fall to the floor when pressing it from the drive gear. Also make sure that the camshaft lobes do not catch on the press plates. |
- Remove the woodruff key from the camshaft.
Installation Procedure
- Install woodruff key (3) on camshaft (2) .
Show/hide table
Illustration 2 | g01032693 |
- Raise the temperature of camshaft gear (1) in order to install the camshaft gear on camshaft (2) . Align the groove (keyway) in camshaft gear (1) with woodruff key (3) in camshaft (2) . Install the camshaft gear on the camshaft.
Note: When you install the camshaft gear, ensure that the marked teeth are facing toward the front.
- Raise the temperature of camshaft gear (1) to 177° C (350° F) in order to install the camshaft gear on camshaft (2) .
End By: Install the camshaft. Refer to Disassembly and Assembly, "Camshaft - Install".
Caterpillar Information System:
UPS 250, UPS 300, UPS 500, UPS 600, UPS 750 and UPS 900 Uninterruptible Power Supply Load Cell - Remove and Install
Installation Guide for Particulate Trap Exhaust Filters{1091} Installation Guide for Particulate Trap Exhaust Filters{1091}
2003/12/01 New Gaskets in the Water Lines Groups {1380}
G3500 Engines Too Much Vibration
G3500 Engines Short Spark Plug Life
G3500 Engines Poor Fuel Consumption
G3500 Engines Noise Coming from Cylinder
2003/11/01 New Gasket for the Turbocharger's Water Lines {1052, 1380}
C-9 Engine for TK711, TK721, TK722, TK732, TK741, TK751, and TK752 Track Feller Bunchers Mechanical Noise (Knock) in Engine
G3500 Engines Low Power/Poor or No Response to Throttle
G3500 Engines Intermittent Engine Shutdown
G3500 Engines Inlet Air Temperature (High)
C32 Marine Engine Electronic Control System Components
C32 Marine Engine Fuel System
2004/01/01 An Updated Version of Troubleshooting Guide, SENR9698 is Now Available {1105, 1400}
2003/11/01 Improved Exhaust Seal for the Exhaust Manifold {1059}
C9.3 Marine Engine Auxiliary Water Pump - Remove
C7 PETROLEUM Petroleum Engine Auxiliary Water Pump - Assemble
G3500 Engines Self-Diagnostics
C9.3 Marine Engine Auxiliary Water Pump - Install
C7 PETROLEUM Petroleum Engine Auxiliary Water Pump - Disassemble
C32 Marine Engine Heat Exchanger
G3500 Engines Location of Components
C15 and C18 Engines for Caterpillar Built Machines Electronic Unit Injector Mechanism