Engine Oil Pump - Install
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Thoroughly clean the mounting surfaces for the engine oil pump.
Show/hide table
Illustration 1 g01030465 - Install idler gear (12) on the engine oil pump. Install bolt (11). Check the end play for the idler gear. The end play for the idler gear is
0.05 to 0.35 mm (0.002 to 0.014 inch) . - Position engine oil pump (10) on the cylinder block. Install the washers and bolts (13).
Show/hide table
Illustration 2 g01030483 - Install O-ring seal (1) and O-ring seal (2) on elbow (5). Position the elbow on the engine oil pump and install bolts (7). Install bolts (6).
- Install gasket (9) and tube assembly (4) on the engine oil pump. Install bolts (8). Install bolts (3).
End By:
- Install the engine oil pan. Refer to Disassembly and Assembly, "Engine Oil Pan - Remove and Install".
Caterpillar Information System:
C9 Marine Engines and C9 Marine Generator Sets Engine Oil Pump - Remove
C9 Marine Engines and C9 Marine Generator Sets Marine Transmission Oil Cooler - Remove and Install
C9 Marine Engines and C9 Marine Generator Sets Engine Oil Cooler - Install
C9 Marine Engines and C9 Marine Generator Sets Engine Oil Cooler - Remove
C9 Marine Auxiliary and Generator Set Engines Fuel Conservation Practices
C7 On-highway Engine Inlet Air Temperature Sensor - Remove and Install
3408C, 3412C and 3412D High Performance Marine Engines Cooling System - Inspect
3408C, 3412C and 3412D High Performance Marine Engines Cooling System - Test
3408C, 3412C and 3412D High Performance Marine Engines Charging System - Test
C7 On-highway Engine Boost Pressure Sensor - Remove and Install
3408C, 3412C and 3412D High Performance Marine Engines Piston Ring Groove - Inspect
C7 On-highway Engine Injection Actuation Pressure Sensor - Remove and Install
3408C, 3412C and 3412D High Performance Marine Engines Air Inlet and Exhaust System
3516B HD Generator Set Cold Weather Operation
C15 and C18 Petroleum Generator Sets Before Starting Engine
C9 Marine Auxiliary and Generator Set Engines Starting the Engine
C9 Marine Auxiliary and Generator Set Engines Cold Weather Starting
C9 Marine Engines and C9 Marine Generator Sets Electric Starting Motor - Remove and Install
EMCP3 Setpoint Programming
EMCP3 Electronic Control Module (Generator Set)
3516B HD Generator Set After Starting Engine
C9 Marine Engines and C9 Marine Generator Sets Coolant Level Sensor - Remove and Install
C9 Engine For Caterpillar Built Machines Fuel Transfer Pump - Remove
C9 Engine For Caterpillar Built Machines Fuel Transfer Pump - Install